answersLogoWhite

0


Best Answer

Half a pound

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How much copper sulphate would you need to treat 100000 gallon dugout?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How much would 36 quarts of ice cream cost at 5.96 per gallon?

(36 quarts) x ($5.96 per gallon) / (4 quarts per gallon) = $53.64


What to do when too much copper sulphate is added by mistake?

Too much copper sulphate will cause an over abundance of free copper in the water and will pose a health risk and also a risk of copper staining (black) over the pool finish. Do not swim. If staining has occurred first add 5L (1 Gallon) of Hydrochloric Acid to the average sized pool (10K Gallons). This will dissolve the copper stain and put it back into the water (maybe some brooming required). Once it is dissolved back into the water begin emptying water from the pool. How much to empty will depend on an accurate reading of what the dissolved (free) copper level is. I prefer no more than 0.2mg/L as an acceptable reading. Therefore if your reading in say 1.0 then you need to remove 80% of the pool water.


How many miles per gallon does a 1997 Chevy blazer that has over 100000 miles get?

i have not found a blazer or jimmy that gets over15 mpg no matter what ya do to it.


Is there an equivalent to Mopar Antifreeze Coolant 5 years 100000 mile formula?

Yes. Look for Zerex G-05. Usually about $13.50/ gallon at NAPA.


How many cubic feet in 100000 gallon?

Using the conversion rate of approximately 7.4805 liquid U.S. gallons to 1 ft3 There are 13368 ft3 in 100000 liquid U.S. gallons. Using the conversion rate of approximately 6.2288 Imperial gallons to 1 ft3 There are 16054 ft3 in 100000 Imperial gallons. Using the conversion rate of approximately 6.4285 dry U.S. gallons to 1 ft3 There are 15556 ft3 in 100000 dry U.S. gallons.


How many liters in 100000 million gallons?

83000.27 L U.S. gallons are different from imperial gallons. 1 Imperial gallon is equal to 4.54609188 litres and 1 US gallon is equal to 3.78541178 litres. Liters on the other hand are the same everywhere. One liter equals 0.26 U.S. gallon or 0.219 Imperial gallon.


How much does 55 gallon drum of copper wire weigh?

Soil weighs about 2.5 times as much as water, which weighs about 8 pounds per gallon. However, one must estimate the porosity (void space) in the soil. Assuming 30% soil porosity means that one gallon of soil would weigh (0.7 x 2.5 x 8 pounds/gallon) about 14 pounds. Therefore, if full to the brim with soil (relatively dry), the drum would weigh about 770 pounds (that is, 55 gallons x 14 pounds/gallon). In reality, there is a range of possible weights, depending on soil density, moisture content, soil composition, etc.


How much copper is in a 50 gal hot warter tank?

A typical 50 gallon hot water tank contains about 3-4 pounds of copper in the form of pipes and connections. Copper is commonly used in plumbing systems due to its durability and ability to resist corrosion.


Gallon per minute through a half inch copper line?

It would be wonderful if you also gave the pressure and told about friction losses


How do you kill lichen in the garden?

You can use a mixture of 6 tablespoons of liquid copper sulfate diluted in 1 gallon of water. You must use this during the dormant season. You don't want this mixture to get on the leaves. You should also prune the tree or shrub at this time.


How much does sulfuric acid cost?

The cost of sulfuric acid can vary widely depending on factors such as purity, quantity, and supplier. It is commonly priced per gallon or per ton, with industrial-grade sulfuric acid typically costing around $200-$500 per ton. Specialty grades may be more expensive.


How many cups of copper sulfate equal a pound?

If it' relatively fine ground copper sulfate crystals, NOT ROCKS and NOT FINE POWDER 1 cup of copper sulfate fine crystal should weigh approximately .7 US pounds. that number should be good enough to calculate copper sulfate to be used to treat a cesspool but not close enough to calculate chemical reactions. A 300 gallon cesspool requires 3 pounds of copper sulfate twice a year to keep tree roots from growing.