0
What else can I help you with?
How much hair do you need to get the juice hair cut?
2to4 inches
How much hair do you need to get a blowout?
A Lot
How much hair do you need to get waves?
About a hair.inch or shorter
Need help taking a broken off distributor?
i need help tacking out a broken off distributor
How much hair do I need to do a full sew in?
The most common question you will hear from women who want to have sew in hair extensions installed is, how much hair do you need to have a full sew in weave? Women have 99 problems, and you would not want hair to be one of them. That is why you need to know the right amount of hair to get if you're going to have a full sew-in.The amount of hair you buy can either make or break your sew-in extensions. In this guide, we will learn about the amount of hair you need and factors you need to consider before buying hair extensions.
How much money do you need to open a hair salon?
Lots
How much do supplies cost for a hair stylist?
This is a really vague question. Hair stylists need a lot of supplies.
How much does cost for labor to put in a distributor?
650.00 It depends on what needs to be done. If you need to remove an old distributor and install a new one, it's only about an hour's work, so maybe $100 or so.
How do you reset timing on 1973 454 Chevy after replacing distributor cap?
No need to if the distributor was not moved.
Why won't your 1989 van start when humid?
moisture in the distributer will stop it starting. next time this happens, try removing distributor cap, and drying it with a hair dryer.replace cap then se if it starts if this fixes the problem you need to get a new seal for distributor cap to stop moisture getting in
Why your hair is growing slowly?
It could either be growing because your hair has started getting split ends, or you are washing your hair too much. Split ends prevent hair growth and that's when you need to get your hair cut, and washing your hair too much strips it of natural oils which help hair grow.
56 Chevy pick up loose distributor?
At the base of the distributor, there is a tab, with a bolt in it. Tightening or loosening this bolt, will do the same, with the distributor. The distributor, by the way, times the motor, so, you will need to retime it.
