you just need 20 bucks and some bud and ill give u mine
What does it cost to build a wind turbine? Capital costs for wind projects are $1,500 - $2,000 per kilowatt of nameplate capacity. How does the cost of wind energy compare to other energy sources? Wind-generated electricity has become more economical to produce in the past 10 years, dropping from as much as 30 cents per kilowatt-hour to 4.5 to 7.5 cents, making it more competitive with other energy sources. The cost to develop and build a wind energy facility is approximately $1.3 million to $1.7 million per megawatt, compared to a cost for gas-fired energy generation of $800,000 per megawatt.
The height of a wind turbine has no impact on the turbine's output wattage. The factors that effect the watts produced are: * The efficiency of turbine design (this is at most 59%) * the density of the air * the radius of the turbine (that is, the length of each fin) * the velocity of the wind passing through the turbine An 80 ft tall turbine would presumably have a fin length (that is, turbine radius) of at most 30 ft. Thus, at sea level on a 59 degree (F) day, in an 8 m/s (18mi/h) wind, with the most efficient turbine design possible, you would generate approximately 15.4 Kilowatts. See: http://en.wikipedia.org/wiki/Wind_turbine#Potential_turbine_power
Ljungstrom Turbine is a Radial Outflow Steam Turbine with two counter rotating discs. Blades are mounted in circles one bigger than the other. Blades of one rotor work as nozzles for the other rotor blades. This turbine design is very forgiving on wet steam. It is said that the turbine design had limitations on scaling up above 30 MW and hence could not compete with Axial Flow Turbines.
I found it for around $22/each for a 10ft length.If you prefer SCH40 PVC you're looking around $30/each for a 10ft length.
That is a question that does not have one single answer. For instance, if the pressure of the steam is raised, less steam is needed. As pressure rises, temperature will also rise due to adiabatic work done on the steam. Also, higher temperatures are needed at higher pressures to make sure the steam does not condense. Raising the temperature of the steam at a given pressure also means that less steam is needed to provide the same amount of energy. Efficiency will also vary, depending on the turbine, and other factors, such ascondenser vacuum. In general, running a pressure around 40 - 45 PSI, it will take 20,000 - 25,000 pounds of steam per hour to generate one megawatt of electricity during that hour. This is with steam that is just above saturation (around 285°F). So, for 5 MW, you'd need around 100,000 pounds of steam an hour. The pipe size would depend on the turbine. A 55 MW turbine (common for geothermal), might have two pipes bringing steam in (one per side), both of which are around 30" in diameter. For 100,000 pounds of steam an hour, much smaller pipes would suffice. However, expanding and then compressing the steam repeatedly is something you want to avoid. Note that these figures reflect more of a geothermal application. The pressure and temperature of steam from a boiler will typically be much higher.
Philip J. Kaplan was born on 1975-10-30.
Mark Vincent Kaplan was born on October 30, 1947, in Chicago, Illinois, USA.
It will cost $30.
$30
30$
about $30
sometimes it cost 30 eachsometimes it cost 30 each
it can cost around £20-£30
I believe it cost 20 to 30 $.
It cost 30 dollars
i may cost about 30$
It cost $30