They are usually a few dollars, probably 10-15 USD at the most depending on where you're getting them from. Nicer, wooden cleaning rods will be a little bit more expensive than the metal ones that come with a starter Flute. The cheap metal rods are usually only a few dollars.
The "stick" is a cleaning rod that is used to clean the inside of the flute. Use a dry cloth, insert in into the rod, and gently insert it into the flute.
After you use your flute and before you store it, you must always remember to clean or dry it. This is because when you blow into the flute, moisture forms inside which can cause the pads to deteriorate. There are some tips for cleaning flute: Use a clean cloth (flannel cloth or a J cloth is good as long as it's not too long or too short) to clean the inside of your flute. Fold the cloth lengthwise in half and thread the edge of the cloth through the slot on the cleaning rod. The cloth must be wrapped snugly on the edge of the rod so that you'll be able to clean the inside of your flute better. Wrap the rest of the cloth tightly around the rod and securely hold the end of the cloth and rod with your hand to avoid bunching up and getting stuck when cleaning the inside of the flute. Now push the cloth-covered rod all the way inside your flute and twist it as you move in and out. Be very careful when doing this. The head joint is the part of the flute that gets the most moisture so be sure to give it a thorough drying. The outside of the flute may be cleaned by gently using a clean damp cloth. Microfiber cloth is a good choice. Now you can store your flute in its case when you're not using it. This will ensure that your flute will last longer and perform well.
You can send it back to the manufacture to have it repaired or you can purchase a .177 Caliber cleaning rod and push the pellet back into the loading area.. The kit cost about $10 for the cleaning rod.
how much will it cost to replace or repair rod for 1996 volvo 960?
If you have a cleaning rod, push it through. You could also use an unbent hanger. The safest thing would be to take it to a repair shop. They'll usually remove it for free.
The average cost to replace a tie rod is approximately $200. You can save about $125 of labor by replacing the tie rod your self.
Buy a new one. It will cost more to repair than it is worth You can buy a cleaning rod (kit) for bb guns, they come in .177 caliber. The kit cost about $10. Use the cleaning rod to push the bb out of the barrel from the muzzle end, push it back into the loading chamber.
Get a larger tip for your cleaning rod.
A tire rod on a 2000 Dodge Neon cost approximately 119.00 to replace. 15.00 at Napa
Goes on the end of a cleaning rod and holds a patch.
This is a tool used to align the cleaning rod with the bore so that it doesn't rub against the sides of the bore when you pull the cleaning rod in and out. This prevents damaging the bore during cleaning.
The cost of a V-Rod Harley Davidson depends on the year and condition. The estimated MSRP on a 2013 V-Rod Harley Davidson is between $15000 and $16000.