answersLogoWhite

0

its cost must be around one thousand to 1500 USA dollers.second hand can be sold cheaper than this. there are many makes of many capacities.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Is the gearbox on a PEUGEOT 806 the same as a 405 or 406?

no


How much does a peugeot 406 accelaretor cable cost?

£1.99 and also 50p for the gromet


Where is the reversing light switch on a Peugeot 406?

the switch is located on top of the gearbox,under the airfilterbox


How do you check gearbox oil in peugeot 406 saloon?

To check the gearbox oil in a Peugeot 406 saloon, first, ensure the vehicle is on a level surface and the engine is off. Locate the gearbox fill plug, usually found on the side of the gearbox casing, and remove it. Use a dipstick or your finger to check the oil level; it should be just below the fill hole. If it's low, add the appropriate type of gearbox oil until it reaches the correct level, then securely replace the plug.


Where the hom on the Peugeot 406 2.0hdi?

WHERE THE HOM ON THE peugeot 406 2.0hdi out sade


Diagram of front suspension on Peugeot 406?

were will i get information for 1996 peugeot 406 petrol


How do you change the ignition coils on a Peugeot 406?

How do you change the ignition coil on a peugeot 406 coupe?


How much gearbox oil for 406 2ltr hdi?

The Peugeot 406 2.0L HDi typically requires approximately 2.5 to 3 liters of gearbox oil, depending on the specific transmission model. It's important to check the owner's manual or consult with a mechanic to ensure the correct type and amount of oil is used for your particular vehicle. Make sure to use the recommended oil specifications for optimal performance.


When was the first Peugeot 406 car made?

The first Peugeot 406 was made in 1995. It was made by a the French Automaker Peugot to be a family vehicle. The 406 was last made in 2003 and then was replaced with the Peugeot 407 model.


How much is a back box for a Peugeot 406?

varies from 40 to 90 pounds and with the manufacturer.


How would you remove a starter motor on a Peugeot 406 LX DT?

how do youremove a starter moto on a peugeot 406 please


Where is the reversing switch on peugeot 406?

The reversing switch on a Peugeot 406 is typically located on the transmission. Specifically, it can be found near the gearbox, often mounted on the side of the transmission housing. To access it, you may need to lift the vehicle and remove any protective covers. Always consult the vehicle’s service manual for precise location and replacement instructions.