The amount of electrical energy it uses in a fixed time is the power, measured in watts, that should be marked on the light bulb when it's bought.
You wouldn't use a potato to screw in a light bulb... if the glass in the light bulb breaks as you're removing it, you can use a potato to take the light bulb out.
Define "light bulb"
Find out what the wattage of the bulb in the fixture is and you will have your answer.
take out light bulb in a dash
One professional will take 1 second to screw in a light bulb and 0.5 seconds to install a bayonet cap light bulb.
that depends on how high up the light bulb is
It should only take one person to switch on a light bulb if it is 6 light bulbs it may take 6 people to switch on a light bulb Der!
You have to take the whole light out, there is two screws to take out, then the light will pull out. Then change the bulb. Greeny
Remove the light bulb connector from the light. Take hold of the light bulb, push in and turn at the same time. The light bulb will come out. Reverse the process to install the new light bulb.
None! as Oranges can't either put up nor light an light bulb! ;)
three. one to screw in the bulb and two to talk about how much better neil peart could have done it.
take bulb out from behind light assembly, under hood. look for wires that is connected to light, this is where the bulb comes out.