Want this question answered?
A stapler is designed in such a way that it can be used with power at the middle or work at the middle. Mostly it is used with power at the middle; in this case it is class 3. If the power is applied at the end it is class 2.
3rd Class Lever 3rd Class LeverTweezers are an example of a third class lever.
the difference is the position of the fulcrum. a first class lever has the fulcrum between the lode and applied force. a second class lever has the load between the fulcrum and applied force. A third class lever has the applied force between load and fulcrum. The load happens to be the thing that you are affecting in the system. On a seesaw the load and applied force changes as either kid goes up, but the lower kid is always the force and upper is the load with the fulcrum in the middle. this happens to be a first class lever. a second class lever could be a bottle cap opener with the fulcrum at the end the bottle cap(load) in the middle and you pushing (force) on the other. a third class lever are like tweezers with the fulcrum on the closed end, force is you pushing in the middle, and affected load is whatever you pick up. There are also compound levers like nailclippers, but by diagramming the whole system it should be pretty easy to discover that it is a first class lever. It's compund because of the use of a lever system
It is not so much as how much pressure as where the pressure is applied. If you keep the egg upright and try to apply pressure at the top and bottom, the egg won't break as easily as much as when you apply it in the middle. The shape of the egg gives greater tensile strength to the ends but the middle is comparitively fragile.
He didn't have a middle name.
The diameter is the length across the middle of a circle. Half of the diameter is called the radius.
the radius is half of the diameter and radius is from the middle of the circle to the edge, whereas diameter is from one end to the other going through the middle.
short for diameter? ... Diameter is the measure of a line across the middle of a circle.
The diameter of the Earth is 12742 km or about 8000 miles.
Circular diameter is the distance from side to side of a circle through the middle.
A diameter is the middle of a circle
The distance from a circle to its center (the dot in the middle) is called 'the radius'. The distance from a circle to a point opposite is called 'the diameter'. The diameter is twice the length of the radius.
The diameter of a circle is the length of the circle from one side to the other, going through the middle of the circle. The radius is the measurement of length from the middle of the circle to the perimeter of the circle. This is half of the diameter.
The diameter is the whole width of the circle across the middle. The radius is the distance from the middle to the edge, so is half the diameter. Therefore the radius would be 8 cm
In basic terms...no. A diameter only applies to circles or spheres. The diameter is the distance across the middle at the widest point and the radius is half of the diameter.
A diameter is a line going through the middle of an object. They should be equally parted when you are finished.
Across the middle, or longways?