0
What else can I help you with?
What is the fork oil capacity on an 89 Yamaha virago 750?
seven inches from the top with the fork collapsed and the spring out
What is fork oil capacity for a Yamaha virago 1100?
The fork oil capacity for a Yamaha Virago 1100 is typically around 10.5 ounces (or approximately 310 milliliters) per fork leg. However, it's always best to consult the owner's manual or a service manual for your specific model year, as capacities can vary slightly. Additionally, ensure to use the recommended type and viscosity of fork oil for optimal performance.
How much fork oil is used for each fork on a 1985 Yamaha virago 1000?
For a 1985 Yamaha Virago 1000, each fork typically requires about 10.5 ounces (or approximately 310 milliliters) of fork oil. It's important to check the specific service manual for your model, as variations may exist based on modifications or maintenance history. Always ensure to use the correct viscosity oil recommended for your bike.
How much oil in forks on a 1995 125 virago?
The 1995 Yamaha Virago 125 typically requires about 0.9 liters (approximately 30 ounces) of fork oil for both forks combined. It's important to use the recommended type of fork oil, usually 10W, and to check for any specific service guidelines in the owner's manual. If you are performing maintenance, be sure to also replace the fork seals if they are worn. Always confirm with the manufacturer’s specifications for the most accurate information.
How do you service front forks on a 1982 Yamaha Virago?
To service the front forks on a 1982 Yamaha Virago, start by removing the front wheel and brake calipers, then loosen the fork clamps at the triple tree. Next, drain the old fork oil by removing the fork caps and sliding the forks out of the triple tree. Clean the fork tubes and inspect seals for wear; replace them if necessary. Finally, refill with the appropriate type and amount of fork oil, reassemble the forks, and ensure all components are securely tightened.
What is fork oil capacity of 1986 virago 535?
The fork oil capacity for the 1986 Yamaha Virago 535 is approximately 10.5 ounces (or about 300 milliliters) per fork leg. It's important to use the correct type and viscosity of fork oil, typically 10W, for optimal performance. Always refer to the owner's manual or a service guide for precise specifications and maintenance procedures.
What is the fork oil capacity of a 1997 Yamaha virago 750?
7 inches measured from the top of the collapsed tube with spring out 10 wt fluid, same measurement as for the 1100
What kind of fork oil should i use for a virago 535 front fork system?
For a Yamaha Virago 535 front fork system, it’s generally recommended to use 10W fork oil. However, you should always check the owner's manual or service manual for specific recommendations, as oil viscosity can depend on your riding style, weight, and local conditions. Additionally, consider using a high-quality synthetic fork oil for better performance and longevity.
What is the fork oil capacity of a 1996 Yamaha Virago XV535?
According to the Clymer manual and other sources, it's 228 cubic centimeters. In each fork tube, presumably. The manual also mentions that the oil level should be 176 mm below the top of the inner fork tube.
How much fork oil for 83 virago 500?
10 oz of 10w fork oil in each leg
How much fork oil for your xv 400 virago?
The Yamaha XV 400 Virago typically requires about 10 to 12 ounces (300 to 350 ml) of fork oil per leg, depending on whether you're replacing seals or just changing the oil. It's essential to check your owner's manual for the specific amount and the recommended oil type, as this can vary slightly based on the model year. Always ensure that you perform the oil change with the fork fully compressed for accurate measurement.
Fork oil capacity on Yamaha xt500 forks?
238ml per fork
