Specific heat refers to the heat needed to raise the temperature of the unit mass of a given substance by a given amount. The heat that is required to warm 1.20 of sand from 20.0 to 100.0 is 73 kJ.
To calculate the heat required, you need to know the specific heat capacity of sand. Assuming it is 0.83 J/g°C, you can use the formula:
Heat (J) = mass (g) x specific heat capacity (J/g°C) x change in temperature (°C)
Therefore:
Heat = 1.20 g x 0.83 J/g°C x (100.0°C - 20.0°C)
Heat = 1.20 g x 0.83 J/g°C x 80.0°C
Heat = 95.04 J
sand have low specific heat capacity.
Heat is transferred from sand to towel to body by conduction because of direct contact.
It has a very low specific heat because it absorbs and releases heat energy very readily.
water
1) Sand has less specific heat, 2) It doesn't mix so easily, so the heat basically stays at the surface.
7.014*10^4
You will need about a bag of cement for this project. You will also need around 0.15 cu.m of sand.
140# of sand is required.
1000 km
Though sand and soil have the same specific heat, sand absorbs more heat.
Due to the properties of sand, when we heat it over Bunsen burner it can be used as heating buffer. The sand would absorb heat even after it is removed so we can use it similarly to a hot water bath but the sand will eventually cool down and need reheating. It is common to use this sand heat bed technique in organic laboratories or when gentle/slow heating is required.
There are different kinds of sand, but one of the most common, quartz sand, has a specific heat of 830 (J/kg°C)
7 bags per 1000 on mortar mix and half a truckload of "mortar" sand aught to do it.
I believe its because of the color, since sand can be a brownish color, the color would absorb the heat from the sun. BUT, if the color was light, like white, it wouldn't absorb as much heat.
The answer really requires a cubic measure - the volume - of the construction. 100 square feet can be covered to a depth of only a grain of sand or several inches (or more) of sand and, obviously, the quantity of sand required will vary accordingly.
no calcium sand is much bigger grains than normals sand and it is easy for a reptile to digest it also retains heat
The specific heat capacity of sand is much less than that of water. Hence sand cools earlier.