0
How much horsepower will your 93 Z28 make with the LT4 hotcam kit?
Wiki User
∙ 15y ago
about 305 horse.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How much extra hp could you get by adding a 266 cam on an lt1 camaro and lt4 valve springs?
I cant give ya exact answer but the 266 is very close to a Lt4 hotcam. Lt4 hotcam with 1.6rr can net you around 30-40 rwhp with proper supporting mods.
How much horsepower does a LT4 have?
330hp, 340tq
How many horsepower does a 1997 Camaro ss 30th AV?
I believe 330HP, for an SLP altered LT4 equipped.
What is the horsepower for a 1996 Corvette?
With the 5.7L LT1 V8 it puts out 300HP and with the 5.7L LT4 V8 it puts out 330HP
How do you install a lt4 intake manifold on an lt1?
i believe you need too get the LT4 heads for that too work
Is an lt4 hot cam a good cam?
because why not
Can you drop a 1996 Chevrolet LT4 engine into an 1989 Chevrolet Caprice Classic?
yes you can use a 1996 lt4 engine into a 1989 Caprice Classic, and its easy. you can mail me at:
How fast is a 1996 Impala SS with the LT4 conversion?
Very fast
Where can i get a vacuum hose schmatic on 96 corvette LT4 I put a LT4 in my 96 firebird?
You can get a 1996 Chevy Corvette vacuum hose schematic diagram at most Chevrolet dealerships. Your local library will have Chevrolet Corvette service manuals with the diagram.
What kind of motor does a 1996 impala SS have?
The 1996 Chevrolet Impala SS is powered by Chevrolet's 5.7L LT1. It was basically the same as the LT4 found in earlier Corvettes but the pistons are Iron, and it is camed for more torque at lower rpm.
How many 1997 Z28 were made with LT-1?
All 1997 z28 and ss were made with the lt-1 engine. They swapped to the ls-1 in 1998. Correct! However there were about 100 that were fitted with an LT4 motor which was a suped up version of a LT1
Replaced ac compressor and clutch on 93 lt4 corvette because the clutch burned out - it's burning again in less than 300 miles - mechanic says its electrical problem with inside ac panel -i dont agree?
you need to check and make sure you are getting a full 12 volts across the clutch coil (while connected to the clutch) you may have a bad contact somewhere and if you are only getting like 8 volts the clutch will burn out at a high rate because it is not fully engaged. make you check the voltage while under a load!!!!
