need more information
Replace the head gasket. Yep.
How do you install a oil pan gasket on 1995 Lexus sc400
Intake & exhaust manifold must be removed. Then the head must be removed. head inspected for cracks or warping, and new head gasket installed. Not a repair for a novice.
blow head gasket
All I have heard is to replace it.
Where is the cabin filter located.
Changing the oil pan gasket on a 1995 or similar year Camry is realtively simple, but does require removal of the exhaust pipe. You will need a new oil pan gasket and a new exhaust pipe flange gasket. Put the car on ramps or jacks to access the undercarriage. Remove the exhaust pipe by removing the 3 nuts holding the exhaust pipe flange to the exhaust manifold. These nuts often rust and prior application of penetrating oil may be required to remove them without damage. Once the pipe is unbolted, work the exhaust system loose from the hanging brackets. In most cases the entire system does not have to be removed since there is enough room to remove the pan with only the front hangers removed. Drain the oil from the engine Remove the 10 mm bolts holding the pan to the block. Remove the old gasket material and scrape any remaining gasket from the block and pan. Install the new gasket. Forma-Gasket or a similar product may be used in small quantities to "glue" the new gasket in place and prevent shifting while the pan is reattached to the block. Reinsall the 10 mm bolts in a cross pattern to ensure the gasket is compressed evenly. Do not overtighten the bolts. Replace the pipe to flange gasket between the exhaust pipe and the exhaust manifold with a new part. Reattach the exhuast pipe to the hangers. Install the 3 bolts connecting the pipe flange to the exhaust manifold. Fill the engine with oil. Pray there are no leaks!
Remove the intake manifold, exhaust manifold, and then remove the head. Scrap off the old gasket and install a new one. Reinstall the head and Torque the head bolts in the proper sequence. Reinstall the intake and exhaust manifold torque the bolts to the proper torque. This is a major repair and not for a novice to try.
ABOUT $1200
Remove the head and replace the gasket. No other way to fix it.
take it to the shop
I'VE BEEN TOLD A SHORTCUT TO REPLACING THE WATER PUMP IS TO REMOVE THE EXHAUST MANIFOLD AND THE WATER PUMP WILL COME OUT EASILY. THEN OF COURSE, YOU HAVE THE EXPENSE OF REPLACING THE EXHAUST MANIFOLD GASKET AND EXHAUST O-RING GASKET. BUT A LOT CHEAPER THAN REMOVING THE WHOLE FRONT OF THE MOTOR. Try a chiltons manual or www.alldata.com If this is a quad four motor, you may not want to try this at home.