Want this question answered?
you can add as much as you want as long as you add enough copper oxide. Hope this Helped you! :-)
100 g of anhydrous copper sulfate (CuSO4) contain 39,81 g copper.
The strength of a base is how much it dissociates in water.
An acid can turn into a base if you mix a much stronger base with it! That way the base acid overpowers the acid and makes the acid a base!
The strength of a base is determined by how much it ionizes in solution. If a base only partially ionizes, then it is considered a weak base.
Neomycin sulfate. Not sure how much or where to get it.
Chromium(III) Sulphate is Cr2(SO4)3 . Chromium(II) Sulphate (much rarer) is CrSO4
200 ppm is 0.02%
gg
The formula for zinc sulphate is ZnSO4. This formula shows that the ratio of zinc atoms to sulphur atoms is 1:1.
Polysporin consists of polymyxin b and bacitracin, two very potent antibiotics. Neosporin has the same ingredients but adds neomycin to the mix. Both are good antibacterials, but some people prefer Polysporin because neomycin can cause skin irritation in some people.
Half a pound
Exactly 33,13035046 grams of copper.
A copper sulphate solution can have different concentrations depending on how much copper sulphate crystals have been added into the water. A typical 1 molar solution of copper sulphate would need 250g of CuSO4, mixed with 700ml of H2O, with 10ml of H2SO4 added with another 290ml of water.
It corresponds to 125,482 american gallons.
you can add as much as you want as long as you add enough copper oxide. Hope this Helped you! :-)
Copper Sulphate is banned in most states. Very toxic stuff. Return the product to the store and get something less toxic and easier to use and that is adequate for the job. Such as Yellow Out or Yellow Treat. Both good products for a green pool.