answersLogoWhite

0

warka dang

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Can sheet metal be bent by hand?

Yes, sheet metal can definitely be bent by hand, but it depends on a few factors: Thickness: Thinner gauges of sheet metal (like aluminum flashing or very thin steel) are relatively easy to bend with just your hands or simple tools like pliers. Type of Metal: Softer metals like aluminum and copper are much easier to bend than harder metals like steel. Size of the Sheet: A small piece of sheet metal is much easier to manipulate than a large sheet. Desired Bend Radius: Sharp bends are harder to achieve by hand than gentle curves. For simple bends in thin, soft metals, you can often get away with using just your hands, a sturdy edge (like a table), or basic hand tools. However, for thicker metals, larger sheets, or more precise bends, you'll likely need specialized tools like a sheet metal brake. ADH MACHINE TOOL might have some content relevant to your specific needs.


How much money do sheet metal workers make in a year?

41,600


How much is 1 sheet metal roofing 20ft long green?

37415


Hold how much pressure can ss304 sheet hold?

304 Stainless has a tensile strength of about 75,000 psi. Its yield strength is about 30,000 psi. Tensile strength is the amount of force required to tear or pull apart the metal. Yield strength is the amount of force required to begin to distort or bend the metal.


How much do sheet metal workers make in North Carolina?

Sheetmetal Journeymen payscale is $20.85.


What is the R-Value of steel sheet metal?

The R-value of steel sheet metal is relatively low, usually ranging from 0.02 to 0.04 per inch. This means that steel sheet metal is not a very effective insulator and does not provide much resistance to heat transfer. Additional insulation such as foam or other materials is typically needed to improve the thermal efficiency of structures made from steel sheet metal.


What does mean recess head rivet nut?

I think you are referring to a method of locating a nut in a piece of sheet metal. A rivet head nut is a nut with has a small projection not much thicker than the sheet metal to which you intend to fit it. This projection fits through a pre made hole in the sheet metal, and the small projection is peened over (deformed by hammering) to fix the nut to the sheet.


What happen when a thin sheet of metal is hammered again and again?

When a thin sheet of metal is hammered again and again, it becomes thinner and wider. This process is known as cold working or forging, and it increases the metal's hardness and strength. However, if hammered too much, the metal can become brittle and crack.


Why does steel gauge go down as it gets thicker?

I can answer it generally. The guages were set up to be the area of sheet metal required to get a certain weight. With thicker sheet metal, you don't need as much area to get to the weight, so the guage number is lower.


An upward bend in a piece of timber?

Crown. The crown goes up. The idea is that the load will straighten it out. If the crown is too much, it will have to be used where smaller pieces will be used.


How much does a journeyman union sheet metal worker make in local 83?

27.81$ per hour + benefits


Does sheet metal expand when it rusts and if so how much?

yes it does cause if one spot gets it it will spread unless taken care of