0
Ideally, none. Realistically a quart in 1000 miles is too much.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
When should a timing belt on a Chrysler Pacifica be changed?
100,000 miles
How much should replacing brake rotors cost on a Chrysler Pacifica?
Replacing brake rotors on a Chrysler Pacifica will vary in price depend on the labor cost. The price should be around $150 dollars.
When should you change a timing belt on a 2005 Chrysler pacifica?
100,000 miles.
My 2005 chrysler pacifica went dead and wont crank?
If your 2005 Chryler Pacifica went dead and won't turn over, you should check the battery and other parts of the charging system such as the alternator and starter.Try giving a jump start to your 2005 Chrysler Pacifica to see if it will accept a charge.
How do you remove brake rotor on 2004 Chrysler pacifica?
chanching rotors on a pacifica is simple pull out the cotter pin in the middle and the rotor should come right off
What octane gas should be used in 2004 Chrysler Pacifica?
Regular 87Regular 87
Should there be an external antenna on the 2007 Chrysler Pacifica?
On my 2005 Pacifica, the antenna is located in the passenger side trunk window. Looks similar to the defroster wires that are on the back window
What pennzoil motor oil should you use for your 2006 Chrysler pacifica touring?
3.5L uses 10w30 3.8L uses 5w30
Where are my VIN numbers on a Chrysler pacifica?
Should be located on a tag viewed from the outside on the dash and also on the engine block. Also check the driver door edges.
How much does it cost to replace the rack and pinion steering on a 2007 Chrysler Pacifica?
Prices vary with location but parts and labor could cost between $711 to $1,231. A power steering flush and 4 wheel alignment should also be done at extra cost.
Where is the oil pressure switch located on a 2004 Chrysler pacifica?
The oil pressure switch is located on the oil filter adapter. Find the oil filter and you should see the oil pressure switch.
How do you replace the front wiper blades on a Chrysler pacifica?
The Chrysler Pacifica has U-Hook wiper blade arm attachments. See video below for Hook-End arms. Essentially there's a tab or button where the wiper blade is inserted into the hook. Press the tab/button and pull wiper out of hook. Sometimes you may have to rotate and flex the blade to make enough clearance. Lastly, your new replacements should have these same instructions on the packaging.
