answersLogoWhite

0


Best Answer

It should be a constant flow as long as the oil pump is turning.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How much oil should come out the pushrods on a 1993 350 engine?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Did the 1993 Jeep Cherokee come with 4.3L engine?

No


What size engine does a 1993 Acura Legend come with?

3.2l


Service engine soon light on 1999 gmc jimmy?

If your engine light has come on for your 1993 GMC Jimmy, you need to take you car in for service. You should make sure that you have enough oil in your car.


What type of engine oil does a 1993 ford aerostar XL use?

A 1993 Ford Aerostar would have come from the factory with ( 5W-30 )


Can you buy pushrods with instructions on how to put them back into the engine for a 1998 Ford Taurus?

No. You will need a maintainance guide from Haynes which is available at Autozone. If you do not have any internal engine mechanical experience, do not attempt this. Take it to a mechanic. Good answer. The pushrods will not have instructions. You may also find the Haynes book or other type repair manuals at your local library. Read all about it and see if you have the tools and time to do the work. The valve cover(s) have to come off and maybe a lot of other things to get to the valve covers.


Did a 1993 5.7 liter engine out of a buick roadmaster wagon have a factory hydraulic roller camshaft?

Yes. The L05 (350) engine in the B-body used a hyd. roller cam, as did the L03 (305). The same code engines used in GM trucks did not come from the factory with the roller cam. Although the block has the provisions to upgrade to the roller assembly, it only came with a hyd. flat tappet cam. If you were to change one over, don't forget the pushrods (they are shorter with the roller setup).


How do you change the spark plugs on a 1993 Ford E150 van?

just take the big engine cover inside the veh, and the whole engine will come to your eyes.


How do you replace a Thermostat in a 1993 RX 7?

directly above the water pump is an elbow-joint where the upper radiator hose connects to the engine....this is where the thermostat is...........remove the elbow (3 bolts) and it should come right out


Will a distributor from a 1993 Honda Civic dx fit on a 1993 Honda Civic ex?

No it will not, the dx did not come with the v-tec engine and the ex did. There are 2 different distributors used.


Why would black smoke come from a 1993 Saturn and then its engine cut off?

It sounds like you've thrown a rod.


How can you tell if your Cadillac fleetwood 1993 has an lt1?

The 1993 Fleetwoods did not come with a LT1 engine. The engine is a L05, 350ci with 185 horsepower with throttle body fuel injection. The LT1 350ci with 260 horsepower was used in the 94, 95, and 96 Fleetwoods.


Why the engine light don't come on?

What engine light? The check engine light should come on when you first start the vehicle and then go out after a few seconds. If it does not the bulb may be burnt out or has been removed.