The Nyko Wii Remote Charging Station uses a standard AC power cord to charge 2 NiMH rechargable batteries for up to 25 hours of gameplay time. You can charge 2 Wii Remotes at the same time.
A full recharge of the Nyko Wii remote takes about one hour to complete.
How much do you want to spend?
Yes, the Nyko Kama Wireless Controller is chargeable. A Nyko Wii Remote Charging Station is required. The controller requires two AAA batteries that provide up to 30 hours of gameplay.
For one remote it will take between an 1.5 to 2 hours to fully charge your wiimote. However, if you are charging two wiimotes it will take twice as long (3 hours to 4 hours) as the energy is being shared between two controllers.
Nyko was created in 1996.
A Bluetooth gaming controller made by nyko
i think nyko teamed up with sony
the charging cradle is just for more comfortable charging you don't need it for charging but its more safe and much more comfortable, and if you mean while the 3ds charging yes the cradle need to be plugged in with the charger so he can get electricity.
Your Nyko Kama uses a propietary battery, and will need to be purchased directly from Nyko.
Unfortunately, the Nyko Air is only available in a corded version.
No
Do not, I repeat, DO NOT use the Nyko InterCooler for your Xbox 360. There have been a large number of cases where the Nyko InterCooler actually shortens the life of the Xbox 360 rather than lengthen it. This happens mainly because the Xbox 360 is set to run on a certain amount of power, and the "brick" supplies that amount of power. When the InterCooler is attached, it saps power from the Xbox 360 to work the fans. In response, the Xbox 360's fans do not get the amount of power that they need to work correctly usually causing the Xbox 360 to overheat. Overheating is the main cause of the infamous 3 red rings of death, the 1 red ring of death, and other fatal problems. Additionally, some cases report that the plastic from the Nyko InterCooler has melted onto the Xbox 360 console. A few people have even been unlucky enough to have the Nyko InterCooler pull out pins from the motherboard upon removal. Again, do not, I repeat, DO NOT use the Nyko InterCooler for your Xbox 360.