Want this question answered?
The iron ring is a device used to hold something such as a flask over a Bunsen burner.
17grams
a tunsten ring is worth 3800 or asking price! ---------------------------------------------------------------- There are big difference from the internet tungsten jewelry stores, but if you ask for the factory price then a ring should be at the range of $25-$80. Also depend on the processing and stone inlay on the ring.
If the ball is held in place by the ring, then it's called a Captive Bead Ring, this means it's only held by the tension of the ring (captive). So to remove the bead just apply pressure to the side of the bead away from the ring and the bead will pop off. If you can't get the bead to pop out then you will need to visist your piercer and have them use a ring expanding plier to open the ring enough so the bead will drop out. If it's a barbell then the bead unscrews from the barbell, turn to the left to loosen the ball, turn right to tighten the ball. ( righty tighty, lefty loosie )
Both the Hiroshima & Nagasaki bombs of WW2 detonated on the ring of fire. Not much beyond the bomb effects. It will depend on yield though and depth if subsurface.
To hold the nose ring watever
it is an internal retaining ring
Retaining rings are a type of fastener used to hold components together on a shaft. The exposed parts of the ring act as a shoulder that retains a component or assembly in place.
The cigarette power sleeve is held in place by a retaining ring at the top of the sleep. Turn the retaining ring to the left. Once the retaining ring is off the cigarette power sleep will come out.
There is a retaining ring that spins on and off. There is a retaining ring that spins on and off. There is a retaining ring that spins on and off.
You will see a white plastic retaining ring where the line connects to the transmission. Do not remove this, but instead push this in evenly toward the transmission while pulling the hydraulic line away from the transmission. One of Ford's "better ideas".
The glovebox lock is held in place by two retaining screws, on the inside of the glovebox, and a retaining ring on the outside. Remove the retaining screws and retaining ring. Reverse the process to install the lock.
The lighted ignition ring is held on with to retaining clips. Pry outward on each retaining ring. The lighted ignition ring will come off.
Remove the oil pressure sending unit retaining ring. Remove the wiring harness from the sending unit. Poll the sending unit out of the engine.
Turn it
you probably need a pair of snap ring pliers
A ring clamp is used to hold a ring securely, without marring it, while you work on it, much preferable to holding the ring by hand or in a hard-jawed vise.