0
What else can I help you with?
How do you reduce friction on a car?
remove as much space touching the surface which will cause friction.
How much does it cost to replace PCV valve on 2001 Ford Expedition?
PCV stands for Positive Crankcase Ventilation. All car engines have a PCV valve and it is located on top of the motor's valve cover. There is a vacuum line attached to it. It pulls out of the valve cover and if you shake it, you should hear a marble knocking inside it. If you shake it and don't hear anything, it's bad. It costs less than 5 bucks to replace. * 4.0L is located in the valve cover near the brake booster * 5.0L is located behind the intake manifold (engine rear)PVC Valve Removal & Installation # Disconnect the oil separator hose from the PVC Valve. # Remove the PVC Valve from the grommet in the crankcase. Grasp the valve and gently remove it from the grommet in the passengers side valve cover. Remove the valve from the hose by carefully twisting it out. # Inspect the grommet for deterioration. To Install; # If necessary, replace the crankcase grommet. # Install the PVC Valve. Install the hose.
How much space does Age of Empires take up on a computer?
AOEIII complete edition takes 3.98 GB on hard disk.
Would a defective EGR valve affect the performance of a Ford Expedition XLT?
Yes, very much so. ____________________________________________ = EGR Valve = 4.2L, 4.6L, 5.4L and 6.8L Engines 1. Disconnect the negative battery cable. 2. Remove the vacuum hose from the EGR valve. 3. On the 4.6L engine, remove the nut and brake booster bracket. 4. On the 5.4L engine, remove the DPFE sensor retaining nuts and place the sensor to the side to allow access to the EGR tube. 5. Disconnect the EGR valve-to-exhaust manifold tube from the EGR valve. 6. Remove the EGR valve mounting bolts, then separate the valve from the intake manifold. 7. Remove and discard the old EGR valve gasket, and clean the gasket mating surfaces on the valve and the intake manifold. To Install: 8. Install the EGR valve, along with a new gasket, on the manifold, then install and tighten the mounting bolts. 9. Connect the EGR valve-to-exhaust manifold tube to the valve, then tighten the tube nut to 25-35 lbs. (34-47 Nm). 10. Connect the vacuum hose to the EGR valve. 11. On the 5.7L engine, install the DPFE sensor. 12. On the 4.6L engine install the brake booster bracket and the retaining nut. 13. Connect the negative battery cable.
How do you remove sludge from an engine?
Aside from a complete tear-down there is not much you can do. Regular oil and filter changes can help prevent that condition.
Where is the pcv valve located on a Buick Century?
it shuold be on the valve cover Some do. It depends on which engine. One of the more inconspicuous is in the 3.3 litre V6, where it plugs into the intake manifold under the alternator. You pretty much have to remove the alternator to even see it clearly.
How do you get the lifters out of a ford 3.0?
If it's an overhead valve engine that has the cam under the intake and not in the heads then you need to remove the intake manifold and the valve covers. Then remove the rocker arms and push rods. Use a valve lifter removal tool to make this job easier. The parts stores like Autozone usually have a loaner you can use for that. I do recommend using a Rust/Varnish remover type spray to soak down the lifter bores BEFORE attempting to remove the lifters to make it much easier. Good Luck!
How much does it cost to replace an EGR valve?
how much does it cost to replace to egr valve on the 2002 mazda protege
Why does the pressure valve keep opening?
Too much pressure or defective valve.
What releases the compression on a 20hp BS during initial start up this one has too much and won't start doesn't turn fast enough even with boost?
The valves release compression. remove the valve covers and check valve clearance they may not be opening
How much would it cost for your 1997 ford escorts tune up with PCV valve replaced and new air filter?
I have had a complete tuneup done on a Ford Tempo for $150.00 -parts and laor.
How much is a PCV valve?
$5
