Want this question answered?
none. work is done when a force is applied thru a distance. holding something stationary does no work.
w=fd w=200x1work=200 joules
The total work done on the weight is zero.
First set a timer for like 15 minutes. Then throw your mind into getting g work done. Set a reward for yourself at the end of 15 minutes. Example: Do your phone for ten minutes.
2
While just holding the weight on his shoulder, the weight lifter does no work! For work to be done, the mass must be moved through a distance … No Movement, No Work! (but don't tell that to a weight lifter …)
none. work is done when a force is applied thru a distance. holding something stationary does no work.
none. work is done when a force is applied thru a distance. holding something stationary does no work.
Answer: It depends upon your definition of "work". Assuming the lifter put the barbell back exactly where and how it was at first, then there was no work done in the physics context. If you mean manual labor, then yes, some work was done.
w=fd w=200x1work=200 joules
valve adjustment should be done only by someone with experance,lifter replacment only by a mechanic ether done wrong will be very costly.
You need not only the weight but how far it is moved (lifted). Let us say 1 meter. The formula is: force x distance = work 150 nt x 1 m = 150 nt-m
A shoulder scratch is also known as Apley's shoulder scratch test. This is a test that is done to determine the motion of the shoulder and to check for limitations.
The weight of the mass 'm' is (m g) .That's the minimum force he has to exert in order to balance the force of gravity andlift the weight vertically. If he exerts more force than (mg), the weight will accelerateup, and he'll just wind up either coasting in the middle, or else retarding it at the top.So the eventual outcome is just applying the force (mg) through the distance 'h'.The time taken for the maneuver has no effect on the work done. It's just the amount ofpotential energy gained by the bar-bell due to its increased elevation.Work = [ (force) times (distance) ] or [ (weight) times (height) ].W = m g h
Shoulder train a ferret -with a lot of patience. I've been working on this. First you have to be in an area without distractions. While sitting on the bed, put your ferret on your shoulder using treat or a toy. Repeat a few times to get the ferret used to sitting on your shoulder. This needs to be done gradually a few minutes a day. When you feel your ferret is sitting on your shoulder and will stay, then start moving around slowly, increasing your movements until you can stand up.
Typically, you would do shoulder shrugs with 2 dumbells, one held in each hand. If you want to do unilateral shoulder shrugs, then hold the dumbell in one of your hands, and let your arm hang straight down toward the ground. Then, you simple raise your shoulder joint straight up toward the ceiling, while keeping your arm straight holding the weight in your hand. You hold this position for 3-5 seconds, then bring your shoulder back to where you started. After you are done with your repetitions, then you can switch the weight to your other hand, and repeat. If you have 2 dumbells, then you can hold one of them in each hand, and do the same movement on both sides simultaneously.
Not a Job to be done without a Manual.[http://www.themotorbookstore.com/index.html Please purchase a Manual and do the job correctly].