If you have a high pressure tanning bed bulb, it will need to be changed after about 1000 hours of use. Low pressure bulbs may need to be changed as frequently as every 600 hours.
The bulbs should be replaced as often as it takes to keep up their tanning power in the shortest amount of time. The average time is after 400 hours this is about the peak for the tanning power, however the bulbs can last up to 10,000 hours before they are innefective.
The typical wattage of a tanning bed bulb is 100W, but you need to check the size of the bed to make sure.
Buying a used tanning may or may not be a wise decision based on several factors. First, you should check to see what the cost of the original, unused product is. Next, you need to take into account who used the tanning bed before you. If it is a commercial tanning bed, chances are good that the previous owner took well care of it. You will also need to check with the previous owner to see if new bulbs are needed. After a tanning bed's bulbs have been used for approximately 600-700 hours, the bulbs will no longer give good tanning results. Lastly, you should check for warranty. Like all things, tanning beds may not be fully functional -- especially if purchased used. If you buy a tanning bed without warranty, you will need to pay for any repairs that might be necessary. On the plus side, buying a used tanning bed can save you a lot of money (upwards of $500).
Who services tanning bedsin my area? I have a Sunvision Pro-28LX2F in my home and some of the bulbs need replacing and perhaps other service. I live in Ojai, ,Ca,93023 phone 805-646-8203
Models need to be changed as often as deemed necessary by the market. Different types of models need to be changed at different times.
comparing to the traditional light bulbs energy efficient fluorescent light bulbs uses 25% to 75% energy and saves money also and it lasts up to 3 to 25 times long so there is no need to replace energy efficient fluorescent light bulbs often.
I don't know the temp but Don't DO IT! Tanning beds work by using UVA and UVB light. Your eyes need to be protected from this. It isn't even enough to just close your eyes, the eyelids are too thin to protect them. Your aquarium does not need this. Use a halogen and you will be very happy and safe.
no
A 110 volt tanning bed will work well. However, a 220 volt tanning bed will operate much more efficiently because of the higher level of current.
5yr/72000mls
every 100,000 km
When used in regulated tanning beds, tanning bulbs can help the skin attain a sun-kissed, healthy glow without exposing the body to the harmful rays of the sun. an important tip to consider when using tanning lamps is that they must be kept clean in order to provide users with the best results. It is recommended to wipe the lamps every two to three hundred hours of use, just to remove any dust particles that may have gathered on the surface. These lamps need almost no other attention, aside from the need to replace them yearly when they dim.