first thing first remove the negative battery cable then you will have to remove your tb start by removing the vacume lines then the four bolt holding your tb on this is a good chance to inspect your lines and clean your tb it's worth it but you will have 2 sensors one is your tps sensor the other is a air temp sensor the tps is the one located on the butterfly of your tb it's easy and you will know what im talkin about but remove it replace it and then reinstall all your stuff make sure to reset the tps sensor by removing the back up fuse for 1 min in your fuse box under the hood
How to replace throttle sensor kia spectra 2003
how to replace the throttle position sensor on a 97 nissan altama
To change a throttle position sensor on a 1998 Bravada, disconnect the negative battery cable. Separate the wiring harness connector on the throttle position sensor and take off the sensor. Replace with new.?æ?æ
you dont!
There is no adjustment, they are electronic. You just replace them.It senses the position of the throttle and sends the information to the computer.
It is a part of the throttle body. You have to replace the throttle body if faulty.
The throttle position sensor, TPS should be in about the same position as it was in earlier models - so the "Related Question" below should also be helpful.
The 1998 Oldsmobile Intrigue throttle position sensor is held in place with two retaining screws. Remove the retaining screws and the wiring harness. Reverse the process to install the new throttle position sensor.
The throttle position sensor is in the throttle body.
The throttle position sensor is on the drivers side of the throttle body. It is right in the middle with a connector hooked to it and two torx head screws holding it in.
The throttle position sensor can be removed by dismantling the chassis in which it sits. This can be done by referencing the owner's manual f the Pontiac Montana.
The function of a throttle position sensor is to monitor the position of the throttle in an internal combustion engine.