30A switch for what? Are you trying to switch a dryer? Are you wiring a heavy-duty disconnect for an air-conditioner or a spa? Please explain what you are trying to do. This question smacks strongly of ignorance. Hire an electrician if wiring a switch is outside of your skill set, espacially if you are switching high current loads.
diagram to hook up switch leg
just nintendo switch to can hook it up to the tv and play with friends
to hook up the tach use the hot lead on the disributor and to any good ground wire and if there is a light hook it to the wire on you light switch
How do you hook up a light to an electrical outlet
to shut the fans on and off by yourself. remove the connector for the wires at the fan. hook a wire from the positive on fan motor to the inside toggle switch, do not hook to switch yet. run a wire from the positive on battery, hook to battery after hooking up switch. hook up the wires to the switch. then the battery. its up to you if you want to install a 15 amp fuse in line from battery to toggle switch.. you can also get the power from the fuse box instead of the battery. this should work for you. if not you may need to ground the other fan wire.
To hook up a solenoid switch, the battery cable and the cable that goes to the starter have to be properly connected. The wire from the alternator goes to the battery cable side.
don't know suck it up!!
id have to look to see why but what you can do is get new fans and hook it up to a toggle switch. when you hook the toggle switch up just flip the switch before it gets too hot
Going for the switch to the fixture; there should be a "switch leg" colors will be orange yellow brown or purple purple is normally a travler but you never know :P Hook up the hot ie black red or blue to one side of switch and the "switch leg to the other side of the switch that's it for that...Now at the fixture there will be the same color switch leg where you will hook up the power to the actual fixture there will be two or three wires coming out of fixture hook white to white and whatever color your switch leg is to the black coming out of fixture and ground to ground if so used the ground will be green in no ground going back down to the switch then on the mounting bracket there should be a green painted screw strip the green wire out of fixture rap it around the green screw and then tighten it down and there your hooked up!!
Hook a switch up to the remote turn on and ground. Before the wiring for the amp.
Not yet possible
Use a RF switch.
et an electrician! always safe
Buy a two-way splitter and hook it up. Then all you should need to do is flip a switch. I have a three-way one in which I have my Wii, my PS2, and my satellite box hooked up. A flip of the switch is all it takes.
It is completely possible to hook up two sets of speakers to one computer . All you should have to do is buy a Y cable and hook that up , and it should be no problem after that . It is a very simple thing for the most part to hook up .
If you can get to the starter, you hook up one side of the switch to the terminal that goes to the battery and the other side of the switch to the small terminal marked with and "S". "S" is for starter. The other small terminal you leave alone. Applying power to this terminal will damage the starter.
Sure, but what you would have to do would be to put the switch in the TEST circuit of the detector.
Go for it
Yes. The Nintendo Switch can be played on your TV.
use a parallel circuit to make many lights light up at the same time as the switch is turned on.
75.00 depending where you run the wire from and to
Oh boy. Well, you can get an inverter and hook that up to two giant 6 volt batteries them hook the positive end up to a switch. Not an easy thing to make look good.
You'll need a router, switch or hub to hook up more than one computer to a network.
there is a switch at the end if ur av cable which has written tv and hd-tv you can switch between them.
Yes, If you only hook up two wire it will work as a single pole