Same as every other relay. All relays have a control side and a load side. The control side has 1 power and 1 ground. It also has a coil of wire that becomes electromagnticly energized causing the LOAD side to close and allow current to flow. So you hop in, turn your ignition key and then the request is sent to the ECM (cars computer) to see if the conditions are correct for the car to be started. The control side of the relay is then energized by the ECM providing a ground for the relay. Current will then be allowed to flow as the control side causes the load side engage.
The starter relay operates the starter soleniod. The relay is located on the firewall at about the 8 O'Clock position looking at the brake booster. It has 4 wires in one connector going to it.
To change the starter relay in a 2002 Kia Spectra, first, locate the relay in the fuse box, which is typically found under the dashboard or in the engine compartment. Remove the cover of the fuse box and identify the starter relay, usually labeled on the inside of the cover. Use a flathead screwdriver to gently pry the relay out, then insert the new relay in the same slot. Finally, replace the fuse box cover and test the starter to ensure it operates correctly.
The starter relay is on top of the starter.
To replace the starter relay in a Lincoln Navigator, first, locate the under-hood fuse box, typically found near the battery. Remove the cover and identify the starter relay, which is usually labeled. Use a flathead screwdriver to gently pry out the old relay and insert the new one in the same position. Finally, replace the fuse box cover and test the vehicle to ensure the starter operates correctly.
Which relay is the starter relay on a 1994 buick lesabre
The starter relay is built on the starter.
The starter relay on a 1994 Chevy Silverado is mounted on the starter. The starter and relay are usually changed as a single unit.
The starter relay is inside the starter. You will need to replace the starter.
There is no relay. The solonoid is on the starter.
The SAC22 does not have a starter relay.
to be protect the motor and electrical equipments.some circuit provide to protect the motor.for exm.DOL starter, OLR to protect the motors....
# 6 is the starter relay in your power distribution box