0
Getting a factory terminal is likely not worth it.
First make sure the battery cable has enough slack to cut off the terminal, shave back the insulation and use a new terminal. If you don't have enough slack, you'll need to replace the entire cable.
If you have enough, remove the battery to save yourself from accidentally grounding/shorting our the battery.
Remove the negative battery cable, then remove the positive. Remove the battery.
Cut the battery cable where the terminal is. Strip about an inch of insulation. For my 2003 TL, I had to use the truck size terminal from Autozone as the normal one would not fit the 2 battery cables. Truck size = $3.50, car size = $2.99, not a big difference. Make sure the cable is free of corrosion. If there is any of the powder blue dust, clean it all out with a wire brush. Get the battery cable into the new terminal and tighten. Use electrical tape to cover any excess uncovered battery cable. Pop the battery back in, install the positive terminal then the negative terminal.
What else can I help you with?
How do you change the battery for 2004 Acura RSX?
To change the battery in a 2004 Acura RSX, first, ensure the vehicle is turned off and parked on a level surface. Open the hood and locate the battery; disconnect the negative terminal (black) first, followed by the positive terminal (red). Remove the battery hold-down clamp, then lift out the old battery. Place the new battery in the tray, reconnect the positive terminal first, followed by the negative terminal, and secure the hold-down clamp.
How do you reset the check engine light on a 2004 Acura TL?
Remove the negative battery terminal for three minutes.
Reset check engine light on 2000 Acura TL?
Disconnect the negative terminal to the battery for 3 min.. It worked for me :)
Where is the starter on a 1991 Acura legend?
The 1991 Acura Legend starter is located on the right hand side of the engine, near the front, at the bottom. You can follow the positive battery cable from the battery to the starter.
Where is the starter on a 1988 Acura Integra rs?
You can find your 1988 Acura Integra starter on the right hand side of the engine. You can follow the positive battery cable directly to the starter.
How do you replace a fuel pump on a 2002 acura 3.2 tl?
To replace the fuel pump on a 2002 Acura 3.2 TL, start by disconnecting the negative battery terminal to ensure safety. Remove the rear seat cushion to access the fuel pump access cover, then detach the cover and disconnect the fuel lines and electrical connectors from the pump. Replace the old fuel pump with a new one, reattach the lines and connectors, and secure the access cover. Finally, reinstall the rear seat cushion and reconnect the battery before testing the new pump.
How do you get check engine light off for 2004 Acura RSX type s?
unhook the negative battery terminal and turn the key on and pump the brakes the turn the key off and hook the terminal back up and there you go
How do you replace the alternator on a Acura TL?
To replace the alternator on an Acura TL, first disconnect the negative battery terminal to ensure safety. Remove any components obstructing access to the alternator, such as the drive belt, air intake, or engine cover. Unbolt the alternator from its mounting bracket and disconnect the wiring harness. Install the new alternator by reversing the steps, ensuring all connections are secure and the drive belt is properly tensioned.
How do you replace the alternator on an Acura TL?
To replace the alternator on an Acura TL, first, disconnect the negative battery terminal to ensure safety. Remove any components obstructing access to the alternator, such as the air intake or engine covers. Unbolt the alternator from its mounting bracket, disconnect the electrical connectors, and then remove the drive belt. Install the new alternator by reversing these steps, ensuring all connections are secure and the belt is properly tensioned.
Why does your Acura RSX takes long to start after sitting for a while?
My super sport toyota Camry does that and we had to replace the ground to the battery
How do you install neutral safety switch in a 1997 Acura RL?
To install a neutral safety switch in a 1997 Acura RL, start by disconnecting the negative battery terminal to ensure safety. Then, remove the shift cable and any necessary components to access the switch, typically located on the transmission. Replace the old switch with the new one, ensuring it aligns properly with the transmission and adjust if needed. Finally, reassemble everything and reconnect the battery.
What is causing a 1996 Acura integra from starting if battery is working fine fuel pump is working and car is cranking?
replace the distibuter
