you have to take it to the dealer
Honda civic remote relay
To program a keyless remote control for a 2003 Honda Civic Si, first, sit in the driver's seat and close all doors. Insert the key into the ignition and turn it to the "On" position, then back to "Off" five times within 10 seconds. On the sixth turn, leave it in the "On" position; the doors should lock and unlock to indicate you're in programming mode. Press the "Lock" button on the remote within 5 seconds, and the doors will lock and unlock again, confirming the remote is programmed. Repeat this step for additional remotes, then turn the ignition off to exit programming mode.
Try it manually, with the actual key. If it opens that way, then the remote sending unit is defective.
You don't. You have to maintain the factory radio in the car somewhere or the keyless entry will not work on 96-98 civics.
The alarm in a 1993 Honda Civic can be disabled using the program mode. To enable the program mode pull the key in the on position while pressing lock on the remote. Do this three times in five seconds and program mode will become enabled.
What about it?
A 1993 Honda Civic alarm has an available program mode. To enable program mode place the key in the on position and press lock on the remote control 3. Do this three times in five seconds. Once in program mode the alarm can be reset.
Not all Honda Civics come with an alarm but I own a 1997 Honda Civic that came with a remote.
The stock alarm on a 2002 Honda Civic can be reset by putting the system into program mode. Program mode is enabled by turning the key to on three times and pressing the lock button on the remote. This process must be done three times in under five seconds.
No it is standard on ex and dx
Yes, you can roll down the windows in a Honda Civic using the key if the vehicle is equipped with a remote keyless entry system. Many models allow you to press and hold the unlock button on the key fob to lower the windows. However, this feature may not be available in all Honda Civic models or years, so it's best to consult the owner's manual for specific instructions.
only dealer can do it