0
The clock has to be set through the comand unit/radio. Push the SERV button on the comand, then go to SETTINGS, then TIME AND DATE. and set the time and date, *note* you will probably have to drive the car to pick up sattilites. and gps position.
Wiki User
∙ 2007-01-03 17:21:53
Add your answer:
Earn +20 pts
How do you adjust clock?
You can go on the back of your clock and see two knobs. Just turn the knobs to adjust the clock.
How do you adjust the clock in a 2001 Chevy van?
First, adjust the hours. Then, adjust the minutes
How do you adjust the clock in a 1995 Corvette?
== ==
How to set the clock on a 2007 Chevrolet Malibu?
Turn off the radio and press the clock button. Use the adj dial to adjust the hour, press the clock button again to adjust minutes.
How do you reset the clock on your computer?
To reset the clock on your computer, right-click on the actual clock, and then click on 'Adjust date/time'
How do you set the clock on an alpine CD player?
Some of them (newer ones) have a setting in its menu called "Clock Adjust"... Older ones, pressing the clock button for 5 seconds, then starts to flash the time, and you adjust it.
How do you set the clock radio on a 1998 Ford Ranger?
While holding the clock button use the seek buttons to adjust the hour and the tune buttons to adjust the minutes
Which bolts do you loosen to adjust the ac compressor on a 1988 grand Am 25L Manual transmission?
The mounting bolts that attach the compressor to the engine.
How do you quiet chimes on a grandfather clock?
Look on the back of the clock. There should be a little switch that will adjust the volume.
How do you adjust clock of 328 2007?
You consult the Owners Manual
Where is the AC tension pulley for a 2000 Chevy Metro?
you dont adjust a tension pulley you adjust the position of the compressor to tighten the belt
How do you adjust the air conditioner idler pulley on a 95 Geo metro?
you dont adjust the pulley you move the compressor,there are two bolts you loosen then an adjustment bolt you screw it or out to move the compressor retighten all bolts and recheck tension
