answersLogoWhite
Clutches and Flywheels
Ford Ranger XL
How To

How to change a 98 ford ranger Clutch fan removal diagram?

272829

Top Answer
User Avatar
Wiki User
2009-04-04 21:54:42
2009-04-04 21:54:42

you will have to have a tool that holds the bearing side of the assembly while you unscrew the nut on the clutch side of the fan. some of the nuts are reversed threads, be sure not to tighten when you should be untightening. Rent the tool for free (deposit you get back whe nyou return the tool) from Advance Auto. Makes the job very easy

1

Related Questions

User Avatar

how to i change a clutch in a 1993 ford ranger

User Avatar

how do I bleed the clutch system in a 2004 ford ranger

User Avatar

www.helminc.com You can find a shop manual for a lot of vehicles.

User Avatar

show me a picture and diagram of 1997 ford ranger timing belt replacement

User Avatar

diagram of fusebox on 1988 ford ranger

User Avatar

How to replace a clutch interlock switch on a 1997 Ford Ranger XLT

User Avatar

you have to have fan clutch wrenches

User Avatar

On the 1996 Ranger the manual shows to lift the clutch pedal every 5,000 miles to adjust the hydraulic clutch , I don't know if yours is the same

User Avatar

On a 1996 Ranger the manual shows to lift the clutch pedal every 5000 miles to adjust the hydraulic clutch - I have no idea if your's is the same

User Avatar

DOT ( 3 ) brake fluid is used for the hydraulic clutch in a Ford Ranger

User Avatar

wiring diagram for 98 ford ranger door alarm

User Avatar

the most common reason for this would be a worn throwout bearing sizing when hot or worn fingers on clutch plate both require removal of transmission to fix

User Avatar

A 1990 Ford Ranger may not shift into gear if the clutch is out. A clutch can be purchased at any auto parts store.

User Avatar

The clutch slave cylinder for a hydraulic clutch is inside the manual transmission bellhousing

User Avatar

changing clutch in 1994 ford ranger ===================================================================== If it is like the ( 1996 ) Ford Ranger The clutch fluid reservoir is in the engine compartment , it is between the Power Distribution Box and the drivers side fender , It takes DOT 3 brake fluid

User Avatar

In regards to your question, the clutch assembly should be the same, the only difference mite be the conector for the clutch line which you can change out with one from an explorer then bolt it in and have fun

User Avatar

In a Ford Ranger , the hydraulic clutch uses ( DOT 3 BRAKE FLUID )

User Avatar

As far as I know it's a hydraulic clutch and is self adjusting

User Avatar

A Ford Ranger pickup truck wiring diagram can be obtained from most Ford dealerships. The wiring diagram can also be found at most auto-parts stores.

User Avatar

A wiring diagram for a 1994 Ford Ranger can be found in the Chilton's manual for that vehicle. You can also find this wiring diagram at most auto parts stores.

User Avatar

This is a quick release and needs a clutch coupling removal tube T88T-70522-A or equivalent. Slide the sleeve toward the slave cylinder while pulling the tube away from the slave cylinder.

User Avatar

there is usually a diagram under the hood


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.