1. Remove wheel.
2. Remove caliper mounting bolts and caliper.
3. Remove caliper mounting bracket bolts and bracket.
4. Disconnect ABS wire lead.
5. Loosen Axle nut and untrhread to end of shaft, leaving attached by a few threads.
6. Remove the three bolts holding the wheel hub to the strut tower. You will need to turn the whhels to one direction to access two bolts and turn in the opposite direction to access on bolt.
7. Pull back on hub while striking loosened axle nut with a heavy hammer in order to free hub from axle splines.
8. Remove axle nut and hub.
9. Reinstall new hub in reverse order 9except for step 7).
how do i replace the hub assembly on a 1997 cavalier 2.3 Ls
you may have a bad front wheel bearing hub assembly. 55 dollars for aftermarket. e z to replace. check brake fluid level too.
To change a front wheel bearing on a 2002 Alero, secure wheels with a chock. Loosen lug nuts and lift the wheel?æwith a jack. Unscrew lug nuts and remove the wheel, the brake caliper, cotter pin, and castle nut. Remove the rotor and the hub bolts. Disassemble the hub assembly, remove the wheel bearing, and replace with new.?æ?æ
part of the hub assembly
With a Hammer
PAY ME
these lights came on my 2000 alero and I needed to replace the wheel hub assembly. So far I have replaced 4 of them. I think its a defect in the car
The wheel bearings are not really replaceable by themselves. This is because they are integrated into the hub assembly. So the answer is that you will have to replace the entire hub assembly to replace the bearings.
most places sell the complete hub assembly. You have to remove the brake assembly there are four bolts holding the hub assembly in place remove and reinstall
Should be of the "peel off" type Remove wheel Remove Caliper mounting bolts Slide caliper off rotor Slide rotor off hub
its in the book owners manual
probably the wheelbearing in the hub assembly not replaceable on its own hub,bearing and abs sensor one integrated assembly and must be replaced as such