Pull off door panel. Roll window half way down. Un-bolt window. There should be four bolts on the door panel that hold the motor. Take the arm off the left on driver side or right on passenger. Then motor should just slide out of the hole.
you need to check the switches first. if not that, it is the power window motor .
yes
how do remove the tailgate's window motor on a toyota 4runner 1997 ?
Remove the inside door panel of your 1997 Mercury Cougar. Remove the wiring harness from the window motor. Remove the window motor linkage. Remove the window motor retaining bolts. Reverse the process to install the new window motor.
The chances are that it will fit. If the 97 camaro originally had a v8 in it then you will have to change the motor mounts on it which can be a pain to do. Source: I stuck a 5.7L from a full size van in my 1983 camaro that originally had a 2.8 V6.
Stock 1993-1997 Camaro (non z28 or Rs) came with a 3.4 sfi motor. All the rs camaros came with the 3.8 sfi motor. So no there is no difference
Replace the motor.
the 1997 camaro doe's not have a fan belt it has a serpentine belt that you can change in about 5 min.
Pull The Motor
needs a new window motor and regulator
The lock switch has nothing to do with the window. If you have power windows and the window switch is bad, you can operate the window by jumping the wires on the switch plug. On my 91 Camaro RS, the window regulator (motor) stopped working. I bought a new regulator at Napa and replaced it. Replacing the window regulator requires drilling out the factory rivets. IMPORTANT! Before you start,you should drill a hole through the door and gear then install a temporary nut & bolt to lock the window in the up postion. This will prevent the window from falling while your fingers are near the gear.
Same as on every other car.