0
Add your answer:
Earn +20 pts
How do you fix a jammed glove box in a car?
In order to fix a jammed glove box in a car, a person will need a credit card, screwdriver, hammer, paper clip, and graphite. Force will have to be used to open up the glove box.
How do you fix glove box latch for 1969 Chevelle?
If there is no adjustments on it you will have to buy a new lock from a chevelle website such as yearone.com.
How to fix latch on glove box on a 1998 Chevrolet Malibu?
I used a short bunge cord hooked on the metal bracket in back of the box to the front latch. Not the best fix - but it works (bertter than paying $90 for a new box).
How do you fix the glove box latch for a 2000 Dodge Durango?
If the plastic part is broken, it can not be repaired. New latch is about $ 50.00.
Where is the blower motor in 2002 Oldsmobile alero?
Behind the glove box. Not an easy chore to fix if you're not mechanically inclined.
How do you fix the trunk release button in the cabin on 2001 Lincoln ls?
Read your manual. There is a switch in the glove box to disable the trunk release button on the dash. you lock the glove box with the regular key. When you give someone the valet key they can not get in the trunk.
Where is the AC Heater relay switch on a 2002 Dodge Stratus?
under the glove box, a bit of a tight spot but easy to fix.
Where is the blower motor resistor located on a 2004 F-150?
behind and below the glove box. 2 screws, and about $40 to fix
Where is the blower motor resistor in a 95' Taurus 3.8 and how do you fix it?
usually on or near the top of the blower motor behind glove box area
How do you replace the blower motor resistor on a 2002 Mazda Protege?
It is located right behind the glove compartment. Remove the glove box and you'll see it. IIRC, it's a white piece. It should be an easy fix.
What are the release dates for The Golf Fix - 2009?
The Golf Fix - 2009 was released on: USA: 9 April 2009
How do you fix heat in 1989 Toyota 4 runner. Control box is stuck on cold side and will not slide.?
under the glove box is the lever the cable goes to. move it by hand and heat will be on. or replace the cable.
