Pull the hood (bonnet) release that is located above the driver's left thigh/knee-depending on anatomy. If the hood pops up a bit, reach into the driver's side of the rubber bumper, close to center and push up on the secondary release platform while lifting up on the hood.
If the primary release doesn't work, take a long, slim rod and stick it into the grill from the passenger side front corner. Have someone push in on the end while you guide it to the vertical stop screw that hangs below the release lever. This will pop the primary latch.
crowbar
Ecklers has the replacement cable and "Installation instructions" which show how to get the hood open so you can relace the cable. Tried to attach the diagram, but no attachment tool here.
how does a coil work in a MGB
MG MGB was created in 1962.
MGB had a 4 cyl 1.8 engine MGB had a straight 6 2.9 engine
what can I do ican,t open my hood
All MGB's that have air conditioning had units installed as dealer-installed options. So, no MGB's came from the factory with A/C.
Beth Hood was born in 1979.
Under the Hood or, on the side of the passanger door when you open it!
do you know where it broke at if it near the handle use vise grips if it is farther down th line you can get a extrnal hood latch kit.
You pull the latch and open the hood.
How to open hood on Toyota echo