Disconnect battery negative, Remove airflow meter and pipe, Disconnect clutch cable and remove clutch arm from gearbox (mind as clutch arm spacer falls out) Remove starter feed and trigger, Remove the three hex headed bolts that hold in starter, Remove starter, it will come out from the bottom and you may need to twist and turn it but trust me it does come out. Refit in reverse order You do not have to remove the clutch cable or arm, but for the rest the info above is correct.
To remove the starter motor on a Peugeot 205, first ensure the battery is disconnected to avoid any electrical issues. Locate the starter motor, which is typically situated near the transmission. Remove the mounting bolts securing the starter, disconnect the electrical connections (including the main power cable and the solenoid wire), and carefully extract the starter from its housing. Reinstalling the new starter involves reversing these steps.
In general, remove negative cable from battery, remove electrical wires from starter, remove bolts holding starter in place, remove starter. Replace starter in reverse order.
Remove - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter
disconnect power from battery, remove wires connected to starter, remove bolts from starter (usually 2), remove starter.
under the air filter
Disconnect the - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter Disconnect the - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter
Remove the cables from the starter. Remove the starter retaining bolts. The starter will come off. Reverse the process to install the new starter.
Disconnect the - battery cable Remove wire at top of starter Remove Starter mounting bolts Remove starter
Remove - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter
Locate the starter at the rear of the engine on the passenger's side. Unplug the wiring. Remove the bolts that hold the starter. Remove the starter.
Under the manifold on the Right hand side............
You have to remove the exhaust manifold to get to the starter.