get a book, simple remove and reinstall, if it's overheating, check the fan switch mounted on the radiator...also, check the cooling system....:) everyone should have a manual for their vehicle, and a professional shop manual should be available at your local library in the reference section, make copies of the appropriate pages, and good luck:)
Remove the hose from the thermostat housing then remove the housing and then the thermostat.
If you have a 1999 Passat V6, the coolant temperature sensor is located in the lower radiator hose.
How do I remove the headlight unit on a V6 TDI Passat year 2000?
the thermostat is behind the alternator! gotta remove the alternator and most of the plugs around it to get to the bolts on the thermostat housing
it is the same for all Mazda with a v6
where is the transmission fluid dipstick on a 1999 volkswagen v6
Drain the radiator into a container. Remove the upper hose at the engine end. Remove the 2 bolts in the thermostat housing and remove the thermostat. Clean the surfaces and install the thermostat and housing. Install the upper hose and refill the radiator.
I have a 2000 passat 2.8 v6 wagon, and have owned a 1999 passat 2.8 v6 sedan. I have been told by VW service departments that the AUTO trans units are SEALED so you cannot add fluid! Not sure about manual trans.
The thermostat is located in the housing where the upper radiator hose connects to the engine.Remove the 2 bolts and remove the thermostat.
replace your abs module its a common problem with v6 passat 99-2003 model.
Follow the upper radiator hose to the engine. The hose is attached to the thermostat housing. Remove the thermostat housing to expose the thermostat.
Thermostat on 1999-2003 Galant V6The thermostat is located on the driver's side top side of engine. Follow the bottom radiator hose located on driver's side up to thermostat housing.
The thermostat for a 1999 Chevy Camaro V6 engine can be found under the hood. It is in the right side of the engine, under the throttle sensor.
In the thermostat housing on the engine. It is under the housing where the lower radiator hose hooks to the engine.
It is under the housing that the upper radiator hose hooks to on the engine. Yup, It's right behind the alternator. I'm pretty sure you have to remove it in order to get to the thermostat. Good luck ......
Under the intake manifold, its very difficult!
Drain the water from your 1997 Chevy Monte Carlo cooling system. Remove the water supply hose. Remove the thermostat housing retaining bolts. The thermostat will lift out. Reverse the process to install the new thermostat.
To change a thermostat on a 1994 Toyota Camry V6, drain the radiator partially. Remove the upper hose assembly, unbolt the thermostat, and put the new one in place. Refill the radiator completely.
In a 2002 Volkswagen Passat the 2.8 litre V6 engine has a timing BELT
You should change the timing belt on the 2003 passat v6 after 100,000 miles is reached.
remove all the coolant in the system take out thermostat put new thermostat in fill system...
Drain the radiator down half way. At the engine end of the top radiator hose is the thermostat housing. Remove the hose and 2 retaining bolts and remove the thermostat. Clean the surface good and install the new thermostat. Refill the radiator.
The thermostat is located right beside the intake manifold on the engine of a 1999 Ford F 150 XLT. The thermostat can be found by following the upper radiator hose.