simple, go to your nearest Ford dealer, they usually have a service area, that way you know its done right, and with a warranty also
Axle seals
It would be recommended to replace the rear axle bearings and axles when they are worn/bad. If the bearings and axles are okay, just replace the seals.
how to replace wheel seal in a 873 bobcat
It will cost approximately $90 to replace the axle seal on your Nissan Pathfinder. The axle seal will cost approximately $30 and require one hour of labor to install.
They are on the inside, next to the differental bearings. The entire axle has to be dissassembled to replace them.
To replace the rear axle seals, lift and support the rear of vehicle, remove the tires, remove the drums, remove the nuts holding the bearing/seal retainer in place, install the drums backwards (that's right, backwards) and secure drums to axle flange with two or three lug nuts, using a large hammer, tap on the drum as to force axle/bearing assembly out from the axle tube, take the axle assemblies to a machine shop to have the old bearings and seals replaced then reinstall the assemblies back into the vehicle. Unfortunately the original bearings have to be destroyed in order to replace the seals.
Can you show me pictures on a dodge neon 1998 on how to remove and replace a front axle.
Yes. The dealer has a tool for that.
take it off, buy a new one, put it on. it worked for me!
You have to remove the brakes, rotors, wheel hubs, axle shafts, diff cover, and differential carrier, seals are on the inside of the axle tubes.
On a 2003 Ford Explorer : Open the drivers door and there is an information sticker on the latch pillar You will find the axle code under " axle " Once you have the axle code you can determine the axle ratio
Replace pinion seal, axle seals or cover gasket unless it is overfilled then drain excess fluid and. Check for proper level