answersLogoWhite

0

This answer is specific to the US and other regions that use 120/240 split phase power.

This is generally not recommended because it would cause the poles of the circuit breaker to be unbalanced. You will need to have access to one of the hot leads, a neutral lead, and an earth ground lead. Dedicated 240V circuits generally do not have a neutral wire, because they only need both hot leads and the earth ground.

User Avatar

Adrain Weissnat

Lvl 10
2y ago

What else can I help you with?

Related Questions

Can you plug a 220v deep fryer into a 110v outlet?

No. Attempting to run an appliance on insufficient voltage can cause damage to the appliance and can be dangerous. Call an electrician and get him to install a 220v plug


If you plug a 1000 w portable heater into a 220v outlet will it burn out?

you must check the voltage and current rating for the heater, the power itself doesnt matter Concur - Some heaters may be rated for the higher voltage which requires less current to run. Watts = Current * Voltage. You risk a fire if you try to run heater above its rated values which should be on a plate on the appliance.


Can I use a 220V oven with 110V outlet?

No, and if you don't have a 220v outlet, you will need an electrician to run a #8 copper wire with a direct line to the electrical panel (40 or 50 amp), depending on the oven's requirments - check the manual.


Can you use the 220v 50hz appliances in 110v 60hz?

Depends. Some smaller stuff can usually run on both, in which case it will be printed on them. If it isn't, you can't run a 220v item on 110v.


Can you run a 110v heater on 220v circuit?

No.It'll overload and fail just about immediately.It's possible - but not recommended - to run two 110 v heaters in series from a 220v circuit.


Will it hurt a 220 motor plugged into 110 outlet?

No, a 220V motor plugged into a 110V outlet will not work properly. It may not run at all or could be damaged due to insufficient voltage. It's important to match the voltage requirements of the motor with the outlet for safe operation.


Can you run a 110v 20a circuit off one leg of a ge thqp 220v 20a breaker?

No, you cannot run a 110V 20A circuit off one leg of a GE THQP 220V 20A breaker. A 220V breaker is designed to provide two hot legs, each supplying 110V, but when using only one leg, it does not provide the proper grounding or neutral configuration needed for a standard 110V circuit. Additionally, this could lead to potential safety hazards and code violations. Always consult a qualified electrician for proper circuit configurations.


Why can't i connect a 220v appliance directly to a 110v power source?

Connecting a 220V appliance to a 110V power source can damage the appliance and potentially cause a fire. The appliance is designed to run on 220V input, so using a lower voltage can overload its components. It's important to use the correct voltage to ensure safe and proper operation.


Is it possible to hook up a 110V TV to a 220V outlet via a power converter?

Using a power converter, it is quite possible to run a 110V television on a 220V supply. The converter ensures that the television will only see 110V. However, the question implies that a television is being taken from one country to another. If that is the case, television signal standards vary throughout the world and RF tuners vary across the world. Although some televisions offer multi-standard operation, many do not. It is worth doing some extra research on the two countries in question before making a decision to ship a television anywhere.


Can you plug a 220v 50 hz refrigerator into a 220v 60Hz outlet?

No, the compressor& fan will run too fast and will more than likely be damaged. It may not be damaged but I would not take a chance.


Can you run a 60hz 110V motor on 50 hz 220V with a step down transformer?

NO dear we can not rotate a 110 vlolt motor on 220,but if your voltage is 110v then y can rotate it on 50hz ,no problem,but it will rotate at lower speed, ENGR. NASEER AHMED,PAKISTAN


What do you need to do to convert a 220V waterfall picture to 110V?

You need to acquire a 110V to 220V step-up transformer. Just be sure to take into consideration the frequency of the AC voltage. I believe the UK runs at 50 hz. and the US is at 60 hz. What that means to you is that the waterfall will run faster here in the States. Also be sure that the transformer's output will match the power consumption of the device you're going to power with it. Do they make such a device? Yes, but you can also use a 220V to 110V step-down transformer in reverse. (Providing it's just a transformer.)