answersLogoWhite

0

you probably have air in cooling system, which is probably caused by blown head gasket(s). Head gasket and intake gasket on these engines are notorious for failing.

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

How do you fix the rear stop lights on a 1996 Chevy Lumina the stop lights only work when the turn signal is on?

Possible bad stop light switch located near the brake pedal.


What make a 1990 Chevy Lumina Car cutoff?

what make a 1990 Chevy. Lumina Car cut off when make a complete stop.


Why did they stop making Chevy Celebrity cars?

The Celebrity was replaced by the all-new Lumina.


What causes both cooling fans to stop working on a 2000 Chevy Lumina?

Check the relay.


What causes both cooling fans to stop working on a 1995 Chevy Lumina?

the thermostat will make both fans become idle if it is not opening. this happened to me on my 95 3.1 lumina


How do you stop 1996 Chevy Cavalier Z24 from leaking antifreeze?

fix it


Chevy lumina 3.1 L eng stall in a stop light or it will stall whill in park?

new EGR valvie and it still stlls


What causes the 94 Chevy Lumina power windows to stop working even if the fuses are good?

Wire, Switch, Motor, window regulator.


Why would a 95 Chevy lumina stop working?

I had the alternator looked at i had the startr looked at I think it is a security thing but cannot place the problem ne ideas......


You have a 1993 Chevy Lumina and when you accelerate to high RPMs the engine starts to choke and then cuts out after a while What could be wrong?

1993 Chevy lumina: check all vacume lines for leaks and or splits around intake.AnswerIf you are not actually moving (just revving up the engine), it is normal for the engine stop at 4000 rpm. (governored)


How do you stop your control panel from displaying stop engine engine overheating when the vehicle is not overheating?

Black duct tape


How do I stop 1994 Chevy Lumina air conditioner from running warm?

Recharging the system with Freeon Gas or Possible replacement of the Compressor! Just maybe, the belt needs tightening.