"How to unplug old antenna to replace with standard antenna on 1989 SunDance
I know that the antenna runs down to below the steering column. I think that you need to unplug it from the back of the radio as well. Is there any easy way to replace an old one?
Remove the old antenna. Attach the universal antenna to the radio and replace the radio after finishing the task. Install the new antenna. Test to ensure the wiring works.
To replace a broken radio antenna on a 2004 GMC Envoy you need to unscrew the old antenna. Next, place the new antenna in the hole and screw into place.
Remove the plastic cover from inside the wheel well to expose the antenna. Remove mounting bolt. To replace antenna purchase an antenna with an adapter. Cut old antenna wire at base and connect new antenna using the adapter.
well you twist it off and twist the other one in its place. yep that's about it
Remove the antenna and the coax and where the coax was route the new coax in the same places and runs where the old was and replacw with new and then screw the new antenna back on
You don't need a new TV or antenna. You need a Digital Converter Box. Go to a Radio Shack, Circuit City or Best Buy. Connect your old antenna to the converter box, connect the converter box to your old TV...all will be well.
unplug old one install new one
THE ANTENNA MAST OPERATES ON A PLASTIC CABLE WITH TEETH ON IT. WHAT HAPPENS IS THE TEETH WEAR OUT OR THE CABLE BREAKS. TO REMOVE THE OLD CABLE REMOVE THE NUT ON TOP AND TURN RADIO ON AND PULL OUT THE OLD CABLE. TO REPLACE THE NEW ONE STICK THE CABLE IN THE HOLE, TURN THE RADIO OFF AND THE MOTOR WILL PULL THE CABLE AND ANTENNA IN AND DOWN AND REPLACE THE NUT. MAKE SURE YOU HAVE ALL OF THE OLD CABLE OUT. IF NOT YOU CAN ACCESS ANY BROKEN OFF PIECES BY REMOVING THE COVER PLATE ON THE SIDE OF THE ANTENNA MOTOR. I HOPE THIS INFORMATION HELPS.
I had to replace mine after it broke. All I did was remove the OLD stub with a crescent wrench and replace it. It took about 1 minute. That is all you have to do.
take the old one off.. and put the new one on! simples
For most people, their old antenna will work just fine. Don't let the people at the electronics store fool you, there is no such thing as an "HD antenna." There is nothing special that needs to be done to an antenna to receive HD signals. In fact, many of the antennas that are being marketed as "HD antennas" are inferior UHF-only antennas that receive a smaller set of signals than your old antenna. However, some people who were barely receiving an analog signal may need to buy a better antenna. Also, if the location of the digital transmitter has changed or the signal strength of the TV station has changed, you may need to re-aim or replace your old antenna. Simply plug the old antenna into the converter box and then plug the converter box into your old TV where the antenna used to go and you will be fine. The converter box will tune in a digital station (some digital stations are HD, some are not) and convert the digital signal into an old-fashioned analog standard definition signal and feed it into your old analog TV. You will not be able to watch shows in HD on your old analog TV, but you will be able to watch a version of the HD broadcast that has been converted into Standard Definition (SD) for you. You will be able to watch all of the digital stations including the HD ones but you will see them in Standard Definition. Standard Definition is 480i. Digital to Analog converter boxes receive all tv transmissions of 1080P , 1080i , 720P , 480P , 480i and coverts them ALL to 480i to watch on a standard definition NTSC Analog TV.