Serpentine Belts
Chevy Tracker
Ford Escape XLT
How To

How to you change serpentine belt on a 2003 Chevrolet Tracker?

464748

Top Answer
User Avatar
Wiki User
2007-09-29 22:56:30
2007-09-29 22:56:30

This is very simple and take 5 minutes. First draw on a piece of paper, the way it's install on your truck than take your ratchet with the 14mm box.

Look at the wheel at the right of the alternator and the power steering, turn the center bolt of that wheel clockwise and it's going to depress the belt. Take it off and pass by the back of the radiator fan and up it's off. To put the new one($18.00) pass the belt the same way following the shema you draw on the paper and when it's o.k. turn the pressure wheel unclockwise to put pressure on the belt. That's it!

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

How do I change rear breaks on a 2003 tracker 6cyl 4x4? the axle is in the way...

User Avatar

how do you change an alternator on a 2003 chevrolet suburban?

User Avatar

how do you change serpentine belt gm 3.4 2003 venture

User Avatar

The 2003 Chevrolet Tracker 2.0 liter 4 cylinder must have a timing CHAIN The Gates website does not list a timing belt for it

User Avatar

There is no such vehicle as a GMC Tracker. The Tracker is a Chevrolet. The firing order is 1-6-5-4-3-2.

User Avatar

Visit our enthusiasts forum at www.trailvoy.com

User Avatar

above the gas tank in the rear of the truck.....you have to get under the tracker to get to it. its easy to change :)

User Avatar

A 2003 Impala does not have a timing belt. It has a chain.

User Avatar

routing for serpentine belt 2003 mercury sable

User Avatar

passenger side of engine about 4 inches below intake manifold, slightly forward of center

User Avatar

Remove screw slide handle forward and pull out from panel. Remove from door operner rod.

User Avatar

Whats the easiest way to change my serpentine belt on my 2003 Toyota celica gt.I need a diagram

User Avatar

On my 2001 it is to the right of steering column just under edge of dash next to center console. On a bracket facing down.

User Avatar

I doubt it very much as they change engine specs every year.

User Avatar

To change the serpentine belt on a 2003 Pontiac Bonneville, loosen the tensioner pulley and remove the old belt. The tensioner pulley is the wheel in the belt system that has a bolt through the middle in a slot that can be adjusted. Put the new belt on and tighten up the pulley.

User Avatar

The 2003 Chevrolet suburban requires five quarts of oil in the motor. The oil filter should be filled with oil, when changing it.

User Avatar

The 2003 Chevrolet Tahoe has 16 valves.

User Avatar

The 2003 Chevrolet Corvette has a V8 engine.

User Avatar

The 2003 Chevrolet Suburban has a V8 engine.

User Avatar

The 2003 Chevrolet Impala has 12 valves.

User Avatar

The 2003 Chevrolet Tahoe has a V8 engine.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.