0
What else can I help you with?
How do you change the belt on a 1983 GM 350?
Wrenches
How do you change the serpentine on a 1999 Mercury GM 4.6 liter?
There should be a tensioning pulley that you lift off of the belt to create slack in the belt to get the belt off. Make sure you have a diagram of the belts routing before you take it off so you know how the new belt goes on. Take a picture or draw quick sketch.
Where do i find the diagram for the serpentine belt on a 1988 Buick skylark?
Go to a GM dealer's parts department or service department. They would know.
Zu welchem fahrzeug gehöhrt GM Part Nr10085752?
To which vehicle does GM Part Nr 10085752 belong? Any small-block V8 Chevrolet. It is a drive belt and part of the Serpentine Accessory Belt Drive System (Part Nr 12497698. This deluxe serpentine belt drive system with air conditioner includes all the components to install on small-block Chevrolet engines. See the link below.
Need diagram for serpentine belt for 1996 buick skylark with v6?
It's on a sticker where the shock absorber is. If it's missing, a GM dealer's service center will have it.
How is serpentine belt ran on a 97 buick lesabre?
There might be a picture of this under the hood. Alot of GM's have this. It is possible that the engine mount will have to be removed for this depending on what engine you have .
How do you adjust a Buick Skylark 1998 serpentine belt tensionor 3100?
There is a special tool for that. Try a GM dealer's service center. They should know which one it is.
How many km before replacing gm serpentine belt?
There is no set mileage to replace the belt. Inspect it for cracks and or frays. If you see cracks or it is frayed or worn then replace it. Also if it becomes stretched to the point it slips, replace it.
Where can I find a diagram of a Serpentine belt arrangement for 3.1 liter GM engine?
Most auto-parts stores can and will provide this as a print-out (may be a minimal cost) when you purchase parts from them.
I have a Buick Regal 1994 3.8L - Can you buy a serpentine belt to by-pass the air conditioning motor?
yes, i have the same car and my air conditioner burned out years ago. instead of replacing the air conditioner i just got a new belt - GM makes a belt specifically for this
What size belt is needed to bypass ac on a GM 2500?
To bypass the AC compressor on a GM 2500, you'll typically need a serpentine belt that is 1-2 inches shorter than the standard belt used for the AC system. The specific size can vary depending on the engine type and model year, so it's best to consult the vehicle's service manual or a parts store for the exact belt length. Generally, a belt size around 96-98 inches is common for many GM 2500 models, but double-checking is advised.
Where can you find a schematic diagram to replace the serpentine belt on your 1995 Chevy blazer?
If the diagram is not still on your radiator shroud or the underneath side of your hood, your GM dealer has the stickers or fiche to show the routing.
