0
What else can I help you with?
What is the ac equivalent circuit for a transistor?
Transistor are DC output, Triac are AC output.
What is the equivalent transistor for ac128?
AC 126
Can transistor be used to increase the strength of an ac signal?
Yes, a transistor can amplifiy an a.c. signal.
How do you access the rear ac transistor?
directions for rear ac transistor access and repair are here: http://ww2.justanswer.com/uploads/thebesthonda/2009-06-11_174838_rear_blower_motor_transistor.pdf
What is the function of an AC transistor in electronic circuits?
An AC transistor in electronic circuits is used to amplify and control the flow of alternating current (AC) signals. It acts as a switch or amplifier to regulate the voltage and current in the circuit, allowing for the manipulation and processing of AC signals for various applications.
What problems can you see in using an AC circuit transistor tester?
farzi....
Internal circuit diagram and working principle of transistor npn sl100?
This mechanism is how a transistor works.
Why the transistor is not used in switching 'AC voltage'?
The transistor is a "single direction current flow" device. Typically, for an NPN device, the collector must be more positive than the emitter for the device to bias on. You could use the transistor in an AC circult, but it would only conduct on half the cycle.
Why you add a positive voltage to the ac signal to allow a transistor to amplify ac signal?
It depends on how you bias the transistor. If you ground the emitter, which is very common, you will need to offset the input signal so you can amplify the full voltage swing.
DHPT in full and how it works?
DHPT in full is Double Heterostructure Photo Transistor. DHPT works by interchanging the double heterostructure's emitter and collector all through when the transistor is in use.
How works bjt transistor as a sram device?
Define BJTSRAM?
What is meant by saying at what current is transistor biased?
The saying "at what current is transistor biased" means to ask the current through the transistor when there is no signal present. Typically, a transistor is biased at the center of its linear region, so as to minimize distortion. This, of course, depends on whether or not the transistor is AC or DC coupled, and where the clipping points might be.
