The fast blow fuse will generally only have a straight wire between the terminals, while the slow blow version will have part of that wire coiled up as a spring.
Any piece of machinery that is designed to use a fast blow fuse should only use a fast blow fuse. For safety reasons this could save your life instead of taking it.
If the fuse is labelled F it is fast-blow or T OR S it is slow-blow, the letter should be on the metal cap on the ends of the fuse.
The time it takes for a fuse to blow, either "fast blow" or "slow blow" is determined by the design of the fuse and is described in a table or graph provided by the manufacturer. In general, the higher the applied overload current, the faster the fuse will blow. Fast blow fuses can open in milliseconds, slow blow fuses can open in several seconds. The fuse used depends entirely on the application and what kind of circuit it is protecting.
Typically the "F" stands for "Fast Blow" or "Fast Acting". A "T", as in T6A, would mean "Time Delay" or Slow-Blow. So, an F6A 250 is a Fast Acting (Fast Blow) 6 Amp 250 Volt Fuse.
2100km
Depends on how you blow it up...... Wow yeah you would ask that..
Capabilities vary by different brands and models of dryer.
You can't as it is physically impossible.
No, it's not physically possible.
A low break capacity fuse typically refers to its ability to interrupt a circuit at lower fault currents, but it does not directly indicate whether it is fast or slow blow. Fast-blow fuses are designed to react quickly to overcurrents, while slow-blow fuses can tolerate temporary surges without blowing. The break capacity and the blow speed are separate characteristics, so a low break capacity fuse can be either fast or slow blow depending on its design.
400 fps
deping on the wether