Switch EVERYTHING electrical off. If the meter still runs, it's showing something is still drawing power.
find your electric Meter and you've found the point of entry, or depending on where the electric meter is in the building, you can trace the cable back from the meter to the point of entry.
== acura speed sensor }
The centre of the (secondary of the) centre tapped transformer is zero volts because that is the point in the circuit on which you based your measurement. If you were to connect the reference meter lead to the end of the winding, then the centre tap would have voltage on it. Its all a matter of perspective, i.e. reference. It also happens that the centre tap is usually grounded and, since you usually connect the meter's reference lead to ground, if you connect the meter's reading lead to the same point, you would logically expect there to be a zero volts differential. Its the same as connecting the two leads together.
That is hole that has been drilled, then had a thread 'tapped' into it so you can insert a machine screw or bolt.
You can not make effective tapped holes in many products.
in a digital meter you get a digital value of your measurement. but in analog meter you have to check the position of the pin along the scale and find out the value.
find your electric Meter and you've found the point of entry, or depending on where the electric meter is in the building, you can trace the cable back from the meter to the point of entry.
one electric meter two shoap in legal .
The unit of electric flux is Volt-meter or Newton-meter^2 Coulomb^-1.
Sure an electrical meter can be enclosed tazim
Cause there is ...
If you are looking for the main panel, look for where wires enter the house or where the electric meter is located.
= Answering "http://wiki.answers.com/Q/How_do_you_find_the_fuse_for_the_1990_acuralegend_if_battry_is_not_charging-o-meter_cable_or_is_it_electric_If_electric_where_is_the_sensor_exactly" =
it will have a finger print
A digital multi meter is what is used to find electric current. A block diagram shows all of the working parts of the multi meter and how they are connected.
An ampere meter
The electric meter for a new house is furnished by the power company. The box that holds the meter and anything past the box is the responsibility of the property owner.