answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2010-03-26 02:17:37

Horitonal or Vertical Output? Horsepower? Keyed with 1/2 moon or full slot shaft? Gear or v-drive system? to comparable ability to transfer power to wheel drive system.verticle.6.5. full slot shaft and gear its a push lawn mower

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Related Questions


model type and code of the mower and from the engine. generally it is metal stamped on the engine and the unit model is near the rear of the mower.


Buy a lawn mower engine repair manual at Border's or Barnes & Noble.


Make absolutely sure that the blade nut is really tight not snug.


very gently, or the mower will get squashed



Not really... it rhymes with mower (as in lawn mower).


depends on the engine but it will be on the engine block.


There is not really a set fuel air mixture. Each engine will be different even if they are the same engine during the build process they are set specifically to the engine.


You can find the operator's manual for that engine at www.briggsandstratton.com. You will need to contact the manufacturer of the mower for the lawn mower owner's manual. Briggs and Stratton did not amke that mower, only the engine.


Mower has a generator, which is turned by the engine. When engine is running, generator produces electricity to charge the storage battery.


No... it was ran low on oil & siezed up. junk mower now.


The belt from the mower engine to the transmission would be called a drive belt.


Where is the location of the idle screw on the Briggs and Stratton 6.0 engine mulcher mower?


By taking a lawn mower and turning it on and going on your lawn making sure you don't miss anything. If you really need this question. That is sad.


You cannot make a go cart out of a lawn mower engine. You can mount a lawn mower engine on a go cart, but the cart must be constructed out of tube steel. Search Google with the term, "Go cart construction".You cannot make a go cart out of a lawn mower engine. You can mount a lawn mower engine on a go cart, but the cart must be constructed out of tube steel. Search Google with the term, "Go cart construction".


I believe it a engine on the back with valves


The pull cord of a lawn mower is used to manually crank the engine to get it started. As the engine is quickly turned, a spark is created which begins combustion.




blew engine cause of low oil.... junk the mower engine & replace or pitch the whole mower... your choice


Depends on the brand mower the engine is installed on. More than likely any standard 12V lawn mower battery will fit.


, I have a BP75AR rally mower. Its very old.It has a Briggs 4 cycle engine. Good luck. Mike


The two closest options for Honda lawn mower engine repair in Indianapolis are the Sears Mower Repair station and the official Honda Repair Shop, both located within city limits.


To swap an engine on a Murry riding mower, it is important to make sure that the new engine is the right match for the mower, by checking the model number. You also need to make sure that the bolt holes line up, so that it will fit safely. Remove the old engine, and then replace the new engine, tightening all the screws and bolts in the reverse order that you followed to remove the old engine.


Go to www.searspartsdirect.com, and type in model # 143.033700 That is the engine specified for that mower. You can then choose between engine, carb, starter, etc. diagrams and parts lists.



Copyright ยฉ 2021 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.