0
What else can I help you with?
Would copper melt in acid?
Only if the acid is above the melting point of copper. However, the copper might dissolve in acid if the acid is oxidizing. If it did, copper ions would be present in the solution formed, but there would not be an metallic copper in it.
How would the crystals of copper sulphate be prepared?
melt the copper sulfate and see what appers
How much energy is required to melt to kilograms of copper?
The energy required to melt 1 kg of copper at its melting point of about 1084°C is approximately 205 kJ. Therefore, to melt 2 kg of copper, you would need around 410 kJ of energy.
Will copper coin melt on 100 degree if put on gas fire for 12 hrs?
Copper melts at around 1984°F (1085°C), so it is unlikely that a copper coin would melt on a gas fire at 100°F (37.8°C) in 12 hours. The temperature would need to be significantly higher to melt copper.
Is it possible to melt metal and copper?
It is possible to melt metals including copper. It requires a very high level of heat, depending on the metal.ADDED@ Not sure why that "and copper". Copper IS a metal.
Can copper melt?
Copper melts at 1084.62 C or 1984.316 F
Does copper melt at room temperatures?
No, copper is solid at room temperature.
Can we mix the iridium in melt copper?
Iridium can form alloys with copper.
Can wood be use to melt copper?
No, wood cannot be used to melt copper because the temperature required to melt copper (1,984°F or 1,085°C) is much higher than the ignition point of wood (around 572°F or 300°C). To melt copper, a heat source such as a furnace or a torch that can reach the required temperature must be used.
Does copper melt at high temperature?
Yes.
What conclusion can you draw the kind of equipment that homo sapiens began to point to melt the copper?
The use of fire, likely from pre-existing campfires, was probably the primary method used by Homo sapiens to melt copper for shaping into tools or ornaments. This would have required the ability to control and maintain a high enough temperature for the copper to melt and be molded into desired shapes.
What is the best metal for a can gold zinc or copper?
copper, it wont melt or bend easilly
