answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How would you prove a bad suction reed in a compressor?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Physics

What do egypians callthere paper made out of reed?

The Egyptians call there reed paper, Papyrus.


What does a reed relay do in a circuit?

Reed switches were used in early keyboards, the two reeds sat apart until a magnet placed over them then they touch, circuit complete.


How does the compressor in a fridge work?

There are many differant types of compressors, so il keep it as simple as I can. the compressor is the heart of the refrigeration system. It is 1 of the 4 main components in a system. It is 1 of the 2 pressure changes in the system, the other being the metering device (many of them as well). refrigerant is sucted from the suction line/pipe into the compressor. once it is in the compressor it is then compressed depending on what type of compressor it is (I will explain a few lower) from a cold low presure refrigerant into a high presure hot refrigerant. can you deduct from that what the purpose of a metering device is? After the frigerant has been compressed it is sent to the condensor coil to be (you got it) condensed. Much like the rain cycle. I would go on but this is to just cover the compressor. The compressor not only keeps the refrigerant moving throughout the hole system it also creates a pressure change. why raise the temperature in a machine that is designed to keep this cool? (I will leave you with that because thats a hole new chapter to expand on) I will give a breif description on how some of the many compressors work. There are 3 catagories of each type of compressor. Hermetique, semi-hermetique and open (or belt driven from a seperate motor).These are the most commonly found compressors.1.reciprocating - Using pistons to compress the refrigerant. as the piston goes down it creates a vacuum opening up to the suction line sucking the refrigerant in until the piston is as far down on its stroke as it can. on the up stroke of the piston it creates a positive pressure pushing the reed (flap over a cylinder head) open pushing the refrigerant into the next cylinder chamber or out into the discharge line. It comes in all three types and used over a wide range of refrigeration feilds.rotary - The rotary compressors have two rotating elements, like gears, between which the refrigerant is compressed. These compressors can pump the refrigerant to lower or moderate condensing pressures. Since they can handle small volume of the gas and produce lesser pressure, they are used in fewer applications. Mostly semi types.screw - The screw compressors comprise of a pair of meshing screws between which the refrigerant gets compressed. They can produce high pressure for small quantity of gas. They consume less power than the reciprocating compressors and are being used widely. Usually because of its size and noise they are rarely used for domestic applications.centrifugal - The centrifugal compressors comprise of the impeller or the blower. As the impeller rotates at very high speed into a volute casing (diffuser) causing a negative pressure (differant to all the others) They can handle large quantities of gas but at relatively lower condensing pressure. Used more for chillers and very big systems (skyscapers) and take a lot of power on start up.scroll -The scroll compressor comprises of two interleaved scrolls of which one is fixed and the other orbits eccentrically without rotating. During its motion small gaps are created between the scrolls where the refrigerant gets compressed. The scrolls can have different shapes like involute, Archimedean spiral or hybrid curve. In another arrangement both the scrolls may be rotating eccentrically to produce the compression.


Which part of accordion vibrates to produce sound?

The accordion reed, which is made of highly tempered steel, vibrates when air is driven through the reed plates by the push/pull movement of the bellows to produce sound.


Does a key or reed switch have a symbol which could be put in a circuit diagram?

yes

Related questions

How old is craftsman 106.154080 air compressor?

I have had my Sears 106.154080 compressor for 58 years. It just broke down. Had to replace 4 little reed valves. Cost me $18.00 including shipping. Its running good as ever again.


How do you check if a compressor motor is functional without turning it on?

There are several parts of the device that can be tested separately, but in general, the only way to truly know if a compressor is working would be to finally just turn it on.You could test the electrical resistance of the motor windings to make certain that there is no open circuit.You could test the capacitor of a Cap Start motor.You could test the limit switch to make certain that it would turn the compressor on and off at the appropriate times.You could turn the compressor shaft by hand to determine if the internal components are functioning as expected.You could even disassemble the compressor head to determine if the reed valves are intact.Since the question didn't specify whether this was a sealed compressor or a conventional compressor it should be pointed out that a sealed compressor is... sealed. You can't get to any serviceable parts so the compressor either works or it doesn't; the only way to determine functionality is to turn it on.


What is the thin piece or cane located in the mouthpiece or som other part of a woodwind instrument?

The the thin strip of cane on a mouthpiece on a woodwind instrument is called a reed.


What are the parts of refrigeration compressor?

The parts of a hermetic (sealed) reciprocating compressor is as follows; motor, crankshaft, bearings, valves, and pressure relief valve and piston(s). there are other smaller parts that can be named but these are the main players. The hermetic scroll compressor is a little different than the reciprocating compressor because it uses an orbiting scroll and a stationary scroll to compress the refrigerant instead of pistons. This is why a scroll compressor cannot run "backwards". The scroll compressor also has an oil pick up tube which differs from a reciprocating compressor. Now a "semi-hermetic" compressor is build like a small engine. It has an oil pump, reed valve plate, unloaders, pistons, bearings, etc. A screw compressor is in a class all to itself.


What color is reed?

Reeds have a fairly dark shade of green, I would compare it to moss green.


Does Nikki Reed have a cell phone?

I would assume so....


How you do get reed of a skunk?

I would recommend calling a professional exterminator.


What two kinds of reed are there?

There is the Saxophone reed and the Clarinet reed


What would be the best reed for a small bio filter system?

I should think Barley reed would be the best, they use it in bales on reservoirs to keep the blue/green algae at bay.


Does the bassoon have the smallest mouthpiece?

Technically speaking, the bassoon has no mouthpiece. It has a bocal and a reed. If the reed is say a mouthpiece then it is not the smallest. The smallest would be maybe an oboe reed or a sopranino saxophone mouthpiece, depending on your definition of mouthpiece.


What rhymes with reed it is to work bread?

if you meant " means to work bread." than it would be Kneed


How much the price of your reed?

I do not have any reed for sale. Reed is a great material to make furniture out of, boats as it is lightweight, you could also use it in building a hut. I think the price would depend on the amount you wanted to purchase.