P = I * E * Cos (theta)
Adding a capacitor in parallel with our load(inductive) this would make our voltage and currents in phase n hence a maximum power factor.
new divide.
No good idea. The CT may not function well at a load beyond 630 amps. It may even fail at higher load (than 630 amps)
8.3 amp
no load voltage - full load voltage by full load voltage
There are several ways to calculate working load limit. One of these includes Minimum Breaking Load (MBL) divided by Working Load Limit (WLL) equals Working Load Limit (WLL).
lolz
You mean heat load? Use Manual J.
To calculate the DG set current, you need the load current and the load voltage. To convert it into kilowatts it is divided by 1000.
To calculate the safe working load of a ship's bollard, you need the working stress and the force applied. These two will help you compute the safe working load.
stress is the ratio between the load and area
If the load is balanced across all three phases, and the power factor is 1.0, the line current would be about 76 amps at full load. For a more typical power factor of 0.85, the current would be closer to 89 amps.