answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered
2011-01-13 14:51:16
2011-01-13 14:51:16

It should as far as both hubs are designed for the same model, for instance, both should be GT, or GS and so on.

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The bearings must be pressed out of the hub and the new ones pressed in. Take it to a garage


Hub Kittle died in 2004.


Hub Bechtol died on 2004-10-22.


what size is the nut holding the front hub on a 2001 ford escape



there is two ways to remove to hubs. the first is brut strength, pry at it with a flat hub bar or screwdriver. the other way is, look at the hub u will see a wire running around the hub, there is a spot on the hub that is flared where the hub meets the rim nearest the tire. find this spot put a wide flat screwdriver or hub bar in till it is past the hard wire running throught the rim and pry till it gives. then move around the rim and pry till the hub pops off


You cannot. You have to buy the whole assembly that includes the wheel hub. the bearings are inside and are lubed for life. When they fail, they are inside the hub to protect your other front end parts and also keeps your wheel from coming off!!!


front hub assembley front hub assembley


how do i replace the hub assembly on a 1997 cavalier 2.3 Ls


there are two holes on the rear brake hub. Find the correct size bolt and screw them in the holes. Screw one then the other till it pops...then slide it off. there are two holes on the rear brake hub. Find the correct size bolt and screw them in the holes. Screw one then the other till it pops...then slide it off.


Hub t spindle-nut: 134 ft lbs.


The front automatic hub from your 2001 Xterra will fit on your 2000 model Xterra. The front automatic of's are exactly the same.


The Zeta Project - 2001 Hunt in the Hub - 2.5 was released on: USA: 20 April 2002


Remove the wheel, Remove the hub, take hub to a press, then press it out, installation is opposite removal.


The Zeta Project - 2001 Hunt in the Hub 2-5 was released on: USA: 20 April 2002


there are two screws that hold the rotor to the hub. be careful not to damage the screws.


The cost to replace hub and tie rod on 2004 Chevy Venture is about $100. However, this cost may vary depending on where it is done.Ê


Hub Diameter--->64.1......bolt pattern---->5 X 114.3


it is built in to the wheel hub and bearing





It's easy, you have to replace the entire hub!When the bearings go bad, you have to replace the whole hub! Simple! It's easy, you have to replace the entire hub!When the bearings go bad, you have to replace the whole hub! Simple!


Measure from the center hub of the front wheel to the center hub of the rear wheel.


I recently did this for my 2004. I found it was cheaper to replace the entire wheel hub then to buy the bearings. The bonus is the new wheel hub comes with the bearings already to go.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.