You either need to turn the steering wheel before turning the key or the ignition cylinder is bad and you need a new one. EDIT:
When you pull out the key to a del sol you can continue to turn the wheel which will lock the steering wheel and the ignition , if you get into the car and can't turn the key , (iN YOUR CASE) try turning the steering wheel and the key at the same time , this will unlock the wheel and the ignition.
we found out that we need to press the ignition "reset button" where is this?
Open door Turn ignition on press valet button on and off 3 times (you will hear chime) press lock button turn ignition off DONE!!
the 98 tc manual says: 1. turn ignition on 2. press door unlock 3 times 3. turn ignition off 4. press unlock 3 times 5. turn ignition on. doors should lock and unlock 6. with ignition still on press unlock. If horn chirps you have toggled autolock feature.
If you have a manual tranny, keep the clutch out and press the ignition button.
Your ignition timing is WAY off.
Try this: Turn the ignition to RUN (do not start), press the unlock button on the keyless remote, ignition OFF. Repeat 2x. Turn the ignition to RUN, press the unlock button on the keyless remote twice, the power locks should cycle to indicate successful programming. Turn the ignition OFF and test remote.
If your 300zx has no power to the entire car and the key is stuck in the ignition you have to press the emergency button located in the ignition. Simply remove the black piece from your ignition.(its a black cap)..and when removed you will see a small red button..if you see that push that and press the "push" black button, turn your key and pop it out.
On the bottom left of the instrument cluster, is a button marked 0. Switch ignition on and immediately press the button. Switch ignition off. Press and hold the button while switching the ignition on. After 10 seconds, the new interval will appear, accompanied by a beep. Release button. Switch ignition off.
Ranges are similar to stove tops. Put your pan over, turn the gas knob (some requires you to press a button for ignition), some has ignition after the knob reaches the end, some ignites when you press the knob, some has no automatic ignition and requires naked fire to light it.
The printing press was invented about 565 years ago.
a printing press
press esc then press save