answersLogoWhite

0


Best Answer

It may well be that the brake light switch has gone faulty If you can, remove the wiring connector block from the switch and bridge the two terminals in the switch connector block. this will bypass the switch as a temporary measure Make sure the ignition is switched on after you have bridged the connections.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: I checked the brake light fuse and it is ok and the gear shifter still won't move out of park .?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why is your battery and hand brake light on on your vauxhall combo?

ive put in brake fuild oil toped that up checked the battery level all ok still the battery light and hand brake light are still on...


1996 Chrysler sebring have checked all fuses and relays and still no brake lights is there an in-line fuse you are missing?

Assuming you have checked the bulbs, check the brake light switch.


What would cause the brake lights to not light up we checked fuses light bulbs are good the brake switch was replaced and still nothing can you guys help?

ya its called go to a mechanic you idiot


No jeep liberty passenger side brake light - changed bulb - checked plug with tester and power is present - but still no brake light - tried second new bulb and still no luck.?

double filament bulb installed incorrectly defective socket bad ground


What would cause the ABS light to turn on in a Honda Civic?

The brake fluid level may need to be topped off. Otherwise if the light is still on after checking the fluid, the ABS system should be checked by a professional. Be sure to use the type of brake fluid recommended on the brake fluid cap.


Why wont the brake lights on your 1998 dodge stratus work Ive checked all the fuses and replaced the brake light switch They still won't work?

try the multifunction switch located on the steering column .


How do you make the shifter move on a 1999 escort zx2 if the button is pushed in and still won't move?

Check to make sure that the brake lights are working - shift interlock and brake lights are a common circuit. Check stop light fuse If the engine is off, there is a small square cap next to shifter. Remove cap and use a screw driver to depress button inside hole where cap was removed. This will unlock the shifter.


When you press the brakes a small light turns on inside the dashboard you check the brake fluid It is full What should you do?

This could mean that the light is out on the brake light. It could be a circuit is not connecting properly. Check to make sure all your lights are working properly. If its still on you should have it checked as it might be a electrical problem instead. == Answer ++ It could also mean you have a problem with your master brake cylinder. You should have your brakes checked out before you have trouble stopping.


93 ford ranger brake fluid lines brakes fine still brake light and abs light stays on also checked fuses and disconnect battrey to try to reset lights still on. no leaks brake pedel fine?

there is an abs motor/switch on chassis rail. if this is not working correctly , your brakes will work but abs will not work correctly all the time untill this swith is replaced the abs light will stay on no matter what you do


We have checked all the fuses and bulbs the brake lights still do not work on ford explorer 2003?

Did you check the switch on the brake pedal assembly?


How can i fix a 1996 ford club wagon with no brake lights turn signals or hazard lights but brake light above backdoor works replaced bulbs and flasher cube checked fuses but still will not work?

check the wiring harness for the opt. towing package under your left tail light


Why the emergency brake light does not come on when emergency brake is applied?

The light on the dash that says the emergency brake light is on could have burned out if it does not light up when the emergency brake is actually on. In some vehicles, this light will not light up until the car is put into gear to warn the driver that the emergency brake is still on.