you stupid diennie
How to put chain sprocket on bobcat
If the drive sprocket is worn out on your chainsaw, the chain will not turn. This is the biggest indicator that it needs repair.
remove bar, chain there should be a small cover over the drive sprocket, held on woth a screw, remove cover, then there should be a screw or bolt holding the sprocket on, remove that, pull old sprocket off, replace it in reverse.
Shaft, belt or chain & sprocket
Yes there is, otherwise it would not be able to drive. The transmission is the gears, the chain and the sprocket. Some motorcycles have a drive shaft instead of a chain.
It allows the chain to transfer power from the pedals to the rear (drive) wheel.
Belt drive is quieter, but can be damaged by stones caught between belt and sprocket.
A 2003 sportster has a chain drive for the promary, firm the engine to the transmission, and a belt drive final drive. The final drive is from the transmission to the rear wheel.
with a standard 17t front sprocket and a 42t rear sprocket the standard chain size is a 525 ( x-ring or O-ring) 124 link.
We find timming mark on the oil pump or on the block ,crankshaft sprocket and on the camshaft sprocket.
In the drive train you have the front chainwheel/ring and the rear sprocket that both engage the chain. The pointy bits on sprocket and chainwheel which allows the chain to grip are called teeth. The ratio between the tooth counts is what determines which gear ratio the bike has.
Belt drive is smoother and lasts much longer. Chain is better for very high torque and big swing arm movement applications, but replacement through chain stretch and sprocket wear a regular unwelcome expense